If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Crankcase vent hose, '87 Scirocco
I'm trying to find a replacement for the crankcase ventilation hose (pipe?)
for my '87 16V Scirocco. VW says they haven't got it and can't get it. Same from a couple of local supply places. This goes from the vent on the front of the engine, to the intake air housing over towards the right. However, it's also got a small tap that goes to the intake manifold above the oil filter about level with the head. There's a picture he http://home.comcast.net/~paralyn/Misc/CVPIPE.JPG The picture is from my other 16V, the pipe here is fine. The damaged one is open over near the crankcase vent. - Bill |
Ads |
#2
|
|||
|
|||
Crankcase vent hose, '87 Scirocco
Bill Leary wrote:
> I'm trying to find a replacement for the crankcase ventilation hose > (pipe?) for my '87 16V Scirocco. > > VW says they haven't got it and can't get it. Same from a couple of > local supply places. > > This goes from the vent on the front of the engine, to the intake air > housing over towards the right. However, it's also got a small tap that > goes to the intake manifold above the oil filter about level with the head. > > There's a picture he http://home.comcast.net/~paralyn/Misc/CVPIPE.JPG > > The picture is from my other 16V, the pipe here is fine. The damaged > one is open over near the crankcase vent. > > - Bill > > Could you make one from some heater hose, fuel hose, and carefully chosen tees? That might be the only solution unless you can find a good one in a junkyard. nate -- replace "roosters" with "cox" to reply. http://members.cox.net/njnagel |
#3
|
|||
|
|||
Crankcase vent hose, '87 Scirocco
"Bill Leary" > wrote:
>I'm trying to find a replacement for the crankcase ventilation hose (pipe?) >for my '87 16V Scirocco. > >VW says they haven't got it and can't get it. Same from a couple of local >supply places. > >This goes from the vent on the front of the engine, to the intake air >housing over towards the right. However, it's also got a small tap that >goes to the intake manifold above the oil filter about level with the head. For what it's worth, www.1stvwparts.com (which is actually Auburn Volkswagen) shows both part numbers as available. 027103217F is for up to vin # ...16000 and 027103217K for ...16001 on. I have noted that occaisonally part numbers will show as available on the site only to get an email back saying they are not available. Might try emailing or calling them (Zach is the internet sales guy) and verify availability. Here is a shot of the ETKA page showing the part: http://web.newsguy.com/racertod/hose.jpg Todd |
#4
|
|||
|
|||
Crankcase vent hose, '87 Scirocco
"Nate Nagel" > wrote in message
... > Bill Leary wrote: >> I'm trying to find a replacement for the crankcase ventilation hose >> (pipe?) for my '87 16V Scirocco. >> ((..omitted..)) > > Could you make one from some heater hose, fuel hose, and carefully chosen > tees? I'm trying something similar. The current hose is damaged where it turns to go into the block. The rest seems to be in good shape. So, I'm going to the parts store tomorrow to find an elbow with the correct diameter at both ends (it gets smaller after the turn) and an in-line junction so I can get the car going again. I'll keep looking for the right part, but I'm not expecting much success. I did this same trick for a water hose that failed about a year back and it's held up fine. > That might be the only solution unless you can find a good one in a > junkyard. I'll try that too probably. This particular part does NOT match the one in any of the manuals I've seen. Those all look like the one racertod send the URL for in another message. This one is an elbow at the block with a run way over to the air box, and with a tap going up about half way along. Like the one racertod shows, except the joint (3 and 3A in that drawing) just aren't there at all. - Bill |
#5
|
|||
|
|||
Crankcase vent hose, '87 Scirocco
> wrote in message
news > "Bill Leary" > wrote: >>I'm trying to find a replacement for the crankcase ventilation hose >>(pipe?) >>for my '87 16V Scirocco. >> ((..omitted..)) > > For what it's worth, www.1stvwparts.com (which is actually > Auburn Volkswagen) shows both part numbers as available. 027103217F > is for up to vin # ...16000 and 027103217K for ...16001 on. > I have noted that occaisonally part numbers will show as > available on the site only to get an email back saying they are not > available. Might try emailing or calling them (Zach is the internet > sales guy) and verify availability. > > Here is a shot of the ETKA page showing the part: > http://web.newsguy.com/racertod/hose.jpg Neither of these is correct for either of my 16V engines. They both have something similar to the pipe labeled "5" in that drawing, except that they have a curve at the end to go into the block rather than the 3 or 3A part shown there. - Bill |
#6
|
|||
|
|||
Crankcase vent hose, '87 Scirocco
On Saturday, June 13, 2009 at 11:14:23 PM UTC-5, Bill Leary wrote:
> > wrote in message > news > > "Bill Leary" > wrote: > >>I'm trying to find a replacement for the crankcase ventilation hose > >>(pipe?) > >>for my '87 16V Scirocco. > >> ((..omitted..)) > > > > For what it's worth, www.1stvwparts.com (which is actually > > Auburn Volkswagen) shows both part numbers as available. 027103217F > > is for up to vin # ...16000 and 027103217K for ...16001 on. > > I have noted that occaisonally part numbers will show as > > available on the site only to get an email back saying they are not > > available. Might try emailing or calling them (Zach is the internet > > sales guy) and verify availability. > > > > Here is a shot of the ETKA page showing the part: > > http://web.newsguy.com/racertod/hose.jpg > > Neither of these is correct for either of my 16V engines. They both have > something similar to the pipe labeled "5" in that drawing, except that they > have a curve at the end to go into the block rather than the 3 or 3A part > shown there. > > - Bill Bump!! Maybe this link will help http://www.mk1autohaus.com/Lifetime-...e-_p_6501.html |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A/C Refrigerant Hose blew up, can I use a hose form a 2.7l concordesame year? | AFX | Chrysler | 5 | September 8th 08 12:02 AM |
Crankcase Reassembly | [email protected] | VW air cooled | 6 | September 5th 06 02:36 AM |
Myths and fallacies regarding egr and crankcase vent in TDIs that have both | [email protected] | VW water cooled | 4 | February 5th 06 11:55 PM |
87 YJ Firewall vent or hose. What is it? | Charlie Dellacona | Jeep | 13 | October 14th 05 04:02 PM |
Crankcase Ventilation Hose Problem | [email protected] | Technology | 0 | July 1st 05 09:27 PM |