If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Honda Accord 92-135 K -3 Questions!
prash_chat wrote:
> Thanks > > Although I have no experience with soldering but I am going to give it > a shot. I just need to unsolder the terminals and solder them back > right? id just touch the iron to the solder joints, and get them to reflow. |
Ads |
#2
|
|||
|
|||
Get a small roll of solder and some solder paste.
Tin iron tip with solder. You might need to flow some new solder with solder paste on the joint. Don't leave iron on the joint too long, or you can damage cicuit board and relay. Or find someone that is experienced with soldering. Examine solder joints first and reflow solder if required. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
hybrids: toyota vs. honda | Magnulus | Driving | 38 | January 18th 05 07:09 PM |
Honda Accord - brights no longer work | Alex Rodriguez | Driving | 2 | January 5th 05 09:31 PM |
Where to get Official Speed Limit Info | [email protected] | Driving | 40 | January 3rd 05 07:10 AM |