|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 22nd 07, 11:03 PM
posted to rec.autos.makers.jeep+willys
|
|||
|
|||
97 ZJ Rear Door Speakers - Infinity 6012i Replacments
I picked up a pair of these. I can use the plastic adapter ring for
mounting them. My question is : Is there a 'smart' way to go about wiring them that preservers the OEM plug/jack hardware? thx, james 
|
| Ads |
|
#2
October 1st 07, 02:17 PM
posted to rec.autos.makers.jeep+willys
|
|||
|
|||
|
97 ZJ Rear Door Speakers - Infinity 6012i Replacments
Thanks for the tip-- I got the wiring harness from Crutchfield, i will
install this week. regards, james On Sep 22, 6:26 pm, c > wrote: > jamest wrote: > > I picked up a pair of these. I can use the plastic adapter ring for > > mounting them. > > My question is : > > > Is there a 'smart' way to go about wiring them that preservers the OEM > > plug/jack hardware? > > > thx, > > james > > You can see if this website has what you need: > > http://www.crutchfield.com/S-o9zbMsO...oup.asp?g=1031... > > This is a page for speaker wire adapters. > > Chris
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GC Infinity Speakers - Pre '99 | RCSnyder | Jeep | 5 | February 25th 06 05:19 PM |
| Queston on Infinity Speakers in a 99 Intrepid | [email protected] | Chrysler | 1 | January 31st 06 08:57 PM |
| FS: NIB Infinity Reference 5002i Car Speakers | JBS | Audi | 0 | July 22nd 05 06:43 PM |
| FS: NIB Infinity Reference 5002i Car Speakers | JBS | BMW | 0 | July 22nd 05 06:43 PM |
| FS: NIB Infinity Reference 5002i Car Speakers | JBS | Dodge | 0 | July 22nd 05 06:40 PM |
Linear Mode
