|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 6th 06, 12:04 AM
posted to rec.autos.tech
|
|||
|
|||
4 cylinder valve adjustment
adjusting valves on a 4cyl, kubota engine. just want someone to verify my
procedure 
|
| Ads |
|
#2
September 6th 06, 01:39 AM
posted to rec.autos.tech
|
|||
|
|||
|
4 cylinder valve adjustment
So what is your procedure? -- JustSayGo ------------------------------------------------------------------------ JustSayGo's Profile: http://www.automotiveforums.com/vbul...?userid=330014 View this thread: http://www.automotiveforums.com/vbul...d.php?t=615879 http://www.automotiveforums.com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 6 | December 7th 06 04:55 PM |
| L98: starts, but won't keep running. | Dave Gee | Corvette | 15 | October 22nd 05 08:43 PM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | June 24th 05 05:27 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | June 8th 05 05:28 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | March 21st 05 05:33 AM |
Linear Mode
