If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#41
|
|||
|
|||
99.5 Golf 2.0 - Losing compression in 1st cylinder - kicking/bucking when driving
"Pete Foley" > wrote in message news:f2d4b745-8423-4a12-8253- snip > Also it may just be me - but it seems that when starting from a stop - > if I let it idle forward for a second, and then slowly/gently accel - > it is better. If I jump too fast it could hesitating/kicking. But as > soon as I feel that first hesitation I need to floor it in order to > save it from going into it's kicking-no throttle-limping along-death > spiral. I would suggest having someone drive it and have the tech look at the scanner/reader to see what the ECM is reading during those times that the engine is acting up. What spark plugs are you running again? I have pulled out sooo many of them that were causing running problems like you described, bad acceleration and missing. Your system doesn't like certain spark plugs especially some of the ones purchased from the local part stores! At least that has been my experience. Original Equipment parts are always good to install! ;-) good luck and keep us updated! |
Ads |
#42
|
|||
|
|||
99.5 2.0 - Losing compression in 1st cylinder - kicking/buckingwhen driving
On Jan 27, 4:16*pm, Pete Foley > wrote:
> And can anyone recommend a Good VW shop in the Philly area? Not quite in the Philly area unless you are north or east. Hillside Auto Repair in Jenkintown. They are in the book. They handle our 1999 VR6 camper, 2001 Saab 9.5SE and 2005 Volvo XC70. They ain't cheap, but they do it right the first time. And they have a habit of turning $1000 repairs into $200 repairs for that reason alone. They are very good at letting you know what to expect over the next few months and what to watch after for maintenance (see "could wait" below). They fix anything with an IC engine... A Foreign Car specialist after Hillside would be Elkins Park Auto Works on York and Church. Rather pricey, right along dealer-costs - but again not given to fixing something for the sake of it. At the same time, Larry will very much want to persuade you to fix those things that "could wait". We go to them when Hillside is overbooked and we are unable to wait. Larry will fix anything but prefers foreign. Both are honest. Hillside is preferred based on cost. Peter Wieck Wyncote, PA |
#43
|
|||
|
|||
99.5 2.0 - Losing compression in 1st cylinder - kicking/buckingwhen driving
In article >,
Pete Foley > wrote: >And can anyone recommend a Good VW shop in the Philly area? Go to click and clacks website http://www.cartalk.com/ and under the mechanics files look for a shop in your area for a VW guy. Terry's in Fallsington is supposed to be excellent. -- Jeeps and dubs and everything's nice... |
#44
|
|||
|
|||
99.5 2.0 - Losing compression in 1st cylinder - kicking/buckingwhen driving
In article >,
Pete Foley > wrote: > >> >> Hmmm problem not fixed.............=............no charge! >> Problem fixed..................=................charge! >> What is wrong with getting your $$$$ back? >> At least that is how I feel! > >I feel the same - but at this point I've paid for the new parts in it >and the labor to put them in. When this was 1/2 way thru (when I [snip] I say write a review on yahoo local for all the places you went. Everyone should do it. It will help those in need for a future mechanic. The reviews really help. -- Jeeps and dubs and everything's nice... |
#45
|
|||
|
|||
99.5 Golf 2.0 - Losing compression in 1st cylinder -kicking/bucking when driving
Ok - So it has been in this new shop (another VW/audi/porsche specific
non-dealear shop like the previous) since last Thursday - and they have "found the problem". They don't think it has anything to do w/ the head. I had asked them to do a leak down test and compression test but they said that they didn't do those because the symptoms did not act like it was an engine/ head problem. They said the car is firing on all cylinders and is solid. There may be a compression leak but it would not cause this problem. All in all the engine fires and runs pretty well. So what they did find is that the wiring harness that lead from the battery to the ecu and other components (including throttle body) had gotten sorta wedged underneath the tranny and the coating had totally rubbed away and wires were exposed - touching each other and the metal on the tranny as well. They said that when they had the car on and touched the wires to the tranny or each other the car would stall out. Doing this it would not go into the kicking problem - but they could replicate the kicking problem when driving. They said one of the wires exposed was going to the throttle body (But now that I think about it - I have a drive by cable so does it need electricity?) So they are fixing the wires up and getting it back to me today. So I'll see if this was it - he is confident this is the problem. I'm just so pessimistic about all of this at this point I just don't really believe him- but I'll see. It took them quite a while to find this - so the labor fee is high, but I expected that. Anyway - just thought I would update. It doesn't make sense to me that if this was the problem why it would take a bit of driving for it to act up - although while initially it was about 45 mins it now does it almost immediately - so maybe it was just getting worse. Also this does sorta make sense as to why it would be worse when making a right hand turn - it would hit the tranny in that case and start shorting out. So - sound believable? Thanks, -Pete |
#46
|
|||
|
|||
99.5 Golf 2.0 - Losing compression in 1st cylinder -kicking/bucking when driving
So from the invoice description:
"Diagnose hesitation and lack of power (sometimes around corners), check fault codes, car loses throttle adaptation around corners sometimes, remove air filter housing, battery and tray to inspect wiring harness from throttle body, main wiring harness was chafing against transmission housing and grounding throttle housing wiring, remove upper radiator hose and oil cooler hoses to repair wiring, replace coolant flange at back of cylinder head and reset codes." They said the coolant flange broke on them when they were taking the radiator hose off so that's what that's about. It got me home OK (when I went to drop it off it acted up on the whole 10 minute trip). I'm going out test driving tonight so I'll see... |
#47
|
|||
|
|||
99.5 Golf 2.0 - Losing compression in 1st cylinder - kicking/bucking when driving
|
#48
|
|||
|
|||
99.5 Golf 2.0 - Losing compression in 1st cylinder -kicking/bucking when driving
On Feb 13, 9:32 pm, TheDM > wrote:
> Pete Foley > wrote in news:ecf119d9-e368-44c2-8724- > : > > > > > > > Ok - So it has been in this new shop (another VW/audi/porsche specific > > non-dealear shop like the previous) since last Thursday - and they > > have "found the problem". > > > They don't think it has anything to do w/ the head. I had asked them > > to do a leak down test and compression test but they said that they > > didn't do those because the symptoms did not act like it was an > engine/ > > head problem. They said the car is firing on all cylinders and is > > solid. There may be a compression leak but it would not cause this > > problem. All in all the engine fires and runs pretty well. > > > So what they did find is that the wiring harness that lead from the > > battery to the ecu and other components (including throttle body) had > > gotten sorta wedged underneath the tranny and the coating had totally > > rubbed away and wires were exposed - touching each other and the metal > > on the tranny as well. > > > They said that when they had the car on and touched the wires to the > > tranny or each other the car would stall out. Doing this it would not > > go into the kicking problem - but they could replicate the kicking > > problem when driving. They said one of the wires exposed was going to > > the throttle body (But now that I think about it - I have a drive by > > cable so does it need electricity?) > > > So they are fixing the wires up and getting it back to me today. So > > I'll see if this was it - he is confident this is the problem. I'm > > just so pessimistic about all of this at this point I just don't > > really believe him- but I'll see. It took them quite a while to find > > this - so the labor fee is high, but I expected that. > > > Anyway - just thought I would update. It doesn't make sense to me > > that if this was the problem why it would take a bit of driving for it > > to act up - although while initially it was about 45 mins it now does > > it almost immediately - so maybe it was just getting worse. Also this > > does sorta make sense as to why it would be worse when making a right > > hand turn - it would hit the tranny in that case and start shorting > > out. > > > So - sound believable? > > > Thanks, > > -Pete > > Yes totally. Your very lucky it didn't toast the alternator diodes. > how many batteries have you gone through in the last year? I suspected > a bad ground as a possibility, although shorting anything that is > postive to the ground depending upon what it's attached to could totally > be the deal. > > Thanks for letting us to know, I've been wracking my brain since you > first posted. > > I knew it wasn't the engine, of that I was 100% sure. Um - I think last Feb/March I had a new battery and alternator put in. But this kicking problem did not start up until late November - so I don't think they were related - but maybe. So far so good. I've been doing a fair amount of driving (I usually don't do too much) and it is still doing OK. I'll give it some more time - a few more weeks and see before I totally believe it is 100% fixed. I'll keep you updated. And thanks again. I think someone mentioned that this was probably a simple problem that was just difficult to find - it seems like that may have been the case. Thanks! -Pete |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Repost - 2001 pictures: 1924 Chrysler B-70 'High Compression' Six Cylinder Engine Right svl (WPC Museum) F.jpg 231021 bytes | HEMI-Powered @ [email protected] | Auto Photos | 0 | March 18th 07 11:28 AM |
2000 BMW 323i Cylinder compression | Greg via CarKB.com | BMW | 10 | April 24th 05 11:28 PM |
no compression in cylinder #3 | marks89lebaron | Chrysler | 4 | April 2nd 05 11:52 AM |
Change of compression due to cylinder to block gasket?! | Matt S | VW air cooled | 0 | March 9th 05 12:42 AM |
No compression in #6 cylinder | [email protected] | Ford Mustang | 3 | January 29th 05 11:53 PM |