A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers » Ford Mustang
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Creating a thread on a metal post?



 
 
Thread Tools Display Modes
  #11  
Old June 4th 05, 08:16 PM
external usenet poster
 
Posts: n/a
Default

mmmm, spooge

"WindsorFox[SS]" > wrote in message
news:Nw7oe.27439$iU.1005@lakeread05...
>
>> ".boB" > wrote in message
>>> Get a piece of tubing that fit's over the posts, and extends past the
>>> post ends about 1/4". Get a screw (like #10), that is the same
>>> diameter as the post, and cut the head off. The screw should fit in the
>>> tube, and the tube should fit over the end of the post. Use JB Weld to
>>> hold it all together. I would even dril a couple of transverse holes in
>>> the tube to allow the JB Weld to spooge out and make a stronger bond and
>>> prevent air pockets.

>
> Hhhhhuh, huhuhuh hhuuh huhh he thaid "spooge", huh huhuhuh....
>
> --
> 3am is _never_ a good hour for a summoning - a moment of lost
> concentration and you've got Nader instead of Nyarlathotep.
>
> Amphetamines are not a good idea either: unsafe at any speed. - Cadbury
> Moose



Ads
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 05:59 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.