If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Unable to Tighten GM Side Mount Battery Terminal
The car is a 1995 Oldsmobile Cutlass with the 3.4L DOHC engine. The
negative battery cable terminal will not get very tight when attached to the battery. I can snug it up to where it just begins to get tight, but that is as much as I can get out of it. It feels as though there is not enough depth to the terminal threads going in to the battery. The other terminal tightens up normally and has no problems. The threads in the battery are fine. I have tried other batteries and have the same problem with the negative battery terminal.. Has anyone else ran across this issue before, and if so how did you fix the problem?. I am planning on replacing the whole cable, but would like to know if there is anything else I should try first. Thanks in advance for your help. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why you should remove the negative battery terminal before doing ANYTHING!!!! | Hachiroku $B%O%A%m%/(B | Technology | 57 | November 19th 07 04:05 PM |
Battery terminal short | Paul | Technology | 6 | July 10th 06 05:39 PM |
Battery terminal bolt replacement | [email protected] | Chrysler | 5 | June 15th 06 11:43 PM |
How to change the battery terminal | Jonelle H via CarKB.com | Ford Explorer | 1 | September 5th 05 01:13 PM |
Water on positive battery terminal? | Leon van Dommelen | Mazda | 13 | August 2nd 05 05:10 PM |