If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
NY State Inspection Emissions Failure
The night before I was to bring in my '98 Explorer for state inspection
my check engine light came on. I corrected the problem and cleared the code and re-set the MIL light. The next morning the car failed due to OBD Monitor Readiness Status: Catalyst, Evaporative System and EGR System "Not Ready". Question: When the code was cleared and the MIL re-set did that also re-set the status of these monitors? From what I have found out so far, there are certain driving conditions that must be met for these tests to be performed. 3 days later I put an Autoray EZ-Read 1000 Code Reader on the car and ran the Monitor Option Menu to read the "Readiness Tests'. The 3 in question all showed a "Completed" status. Does this mean the OBD Monitor Readiness Status for these 3 tests are now "Ready" and the car will pass inspection? Thanks for the help. Rob |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
California Emissions for 2000 Ford(49state) HELP! | TheSmogTech | Technology | 0 | January 31st 05 11:23 PM |
Maryland State Emissions test failure-any suggestions? | old school bmw owner | BMW | 55 | December 14th 04 11:40 PM |
Maryland State Emissions test failure-any suggestions? | old school bmw owner | Technology | 59 | December 14th 04 11:40 PM |
TDI emissions tested during MA vehicle inspection? | Model Citizen | VW water cooled | 2 | November 12th 04 08:12 PM |
Integra Emissions Failure | Dkakd | Honda | 13 | November 8th 04 09:14 AM |