If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Suggestions on new clutch needed
Have a '71 Grande with M-code 351C-4V.
Has a toploader with 9" rear end from a Mach 1. Someone suggested a CenterForce. Any comments? mike |
Ads |
#2
|
|||
|
|||
Suggestions on new clutch needed
"goodnigh" > wrote in message nk.net... > Have a '71 Grande with M-code 351C-4V. > Has a toploader with 9" rear end from a Mach 1. > Someone suggested a CenterForce. Any comments? > > mike > > I run one (an original CenterForce dual friction) behind a very potent 1971 351 Cleveland -4V. It was sold as an "off road only" variant. The best thing about it besides how well it hooks up, is how smooth and streetable it actually is. I am very satisfied with mine and give it a two thumbs up... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about repairing clutch plate on A/C ... pin needed | Greg Bailey | Technology | 0 | August 10th 06 12:28 AM |
Explanation needed of Mercury Marquis cooling fan clutch operation | Danny | Technology | 6 | June 3rd 06 08:56 PM |
1994 Ford Ranger Clutch slipping when hot- clutch has 1000 miles on it. | RobertJohnC | 4x4 | 1 | November 24th 05 11:43 PM |
REALLY Old Pine Sap removal - Suggestions needed | Karl J. North III | BMW | 3 | May 4th 05 04:37 PM |
'97 Cobra clutch suggestions... | JS | Ford Mustang | 0 | January 8th 05 05:41 PM |