If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Seat Belts and roll bars
My CJ has an aftermarket roll bar on it. When the roll bar was installed,
the installer drilled a few holes and used a standard bolt and nut to hold the seat belt bracket to it. Not to industry standards, I'm sure. I have been looking for the proper swivel type connection and bolts and, so far, I have not found them. All I can find are the replacment belts and I do not need any of those. Thanks, Chip |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Seat belts | kent | Saturn | 1 | August 31st 04 04:58 AM |