If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Repost: No high beam on chevrolet cavalier ( with update! )
Hi there.
Thanks for the replies to my previous post. I thought I should repost it with the new news as the older one gets left way behind. I went through pretty much everything I was advised on from before but still had the same problem. Changed the relay also. I then noticed that the connection wasn't too clever on the actually plug that fits into the bulb on the passenger side high/low beam light. (It's a plug with an orange and a blue wire going in but it's sealed) Got a new one and connected the cables ............. BINGO ........ all lights running as normal. Great I thought. Wrapped the joints seperate in electrical tape and then sealed everything up. Started up the car but then everything went back to the problem stage :-( This morning, I just unwrapped all the black tape and left the wires bare (separated of course) started up and all the lights work !!! What on earth is going on there? Seal them up and I have a problem, leave them bare and everything works. It's so odd it's quite comical. Hopefully someone else has come across this problem and can put me out of my misery. Thanks and look forward to any replies. Andrew |
Ads |
#2
|
|||
|
|||
Perhaps you have a mechanically flaky connector and the act of wrapping
electrical tape around this and that knocks it loose. This would jibe with the venerable troubleshooting wisdom that connectors are often the site of weird intermittent problems. A brushable rubber product called "liquid electrical tape" might insulate them without further disturbance and also provide some mechanical stabilization, but if you conclude that the problem is definitely the connector (does wiggling it or its wires reproduce the symptoms?) replacing it would be the high-road solution. Cheers, --Joe |
#3
|
|||
|
|||
On Sun, 21 Aug 2005, andrew123 wrote:
> I went through pretty much everything I was advised on from before but > still had the same problem. Changed the relay also. I then noticed that > the connection wasn't too clever on the actually plug that fits into the > bulb on the passenger side high/low beam light. (It's a plug with an > orange and a blue wire going in but it's sealed) Got a new one and > connected the cables ............. BINGO ........ all lights running as > normal. Great I thought. Wrapped the joints seperate in electrical tape > and then sealed everything up. Started up the car but then everything > went back to the problem stage :-( Most of the replacement 9005 bulb plugs you get at a parts store are very poor quality. You might want to contact Candlepower (candlepowerinc.com), they have the actual plastic housings and terminals so you can crimp your own onto sturdy (12 or 14 gauge) wire. |
#4
|
|||
|
|||
Thanks for the replies.
The new plug seems to be ok going into the actual bulb socket. The wires in the old one were loose. The problems seems to arise from the new connections. The two wires coming off the new plug are around 6 inches. I have connected these to the old original two wires coming out the depths of the car. When the new connections are left open showing just the actual wire joints, the lights work fine. Cover them up with electric tape and put everything back together, I lose the lights. Strange. Going to try it again in 10 mins a see what happens Andrew |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
defective high beam switch | cranky-yankee | Ford Explorer | 0 | May 14th 05 09:44 PM |
Chevrolet Cavalier | Import Killer | Technology | 4 | May 9th 05 03:52 PM |
e28 high / low beam question | David Tyrrell | BMW | 3 | April 5th 05 11:39 PM |
2002 530i high beam installation | William Levenson via CarKB.com | BMW | 0 | April 2nd 05 02:39 AM |
Driving lights and high beam question: | Matthew Russotto | Driving | 21 | December 10th 04 04:21 AM |