If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
The HEMI
This is an interesting article. I've heard the HEMI Magnum is a beast,
I would love to get my hands on one of those. HEMI's HOT! - Chrysler Finds Winning Formula AUBURN HILLS, Mich., Dec. 9, 2004; The HEMI(R) continues to build momentum. Since first introducing the all-new 5.7-liter HEMI V-8 engine for the 2003 model year, Chrysler Group has sold more than 300,000 vehicles with a HEMI inside. In Chrysler Group vehicles where HEMI is offered, the take-rate is 46 percent. "The HEMI continues to resonate with consumers and has essentially become a brand within our brands," said Eric Ridenour, Executive Vice President, Product Development, Chrysler Group. "And with MDS, our modern cylinder deactivation system, the HEMI seamlessly moves from eight cylinders to four cylinders and back. The only thing customers notice is a savings in fuel economy of up to 20 percent." On a product-by-product basis, the HEMI remains a popular engine choice. For Dodge Durango, the take-rate is 54 percent. The 2005 Dodge Ram is at 46 percent while Dodge Magnum and Chrysler 300C are at 43 percent. Jeep(R) Grand Cherokee's take-rate is 29 percent. MDS is available on Dodge Magnum, Chrysler 300C and Jeep Grand Cherokee. In the spring of 2005, Chrysler Group will up the ante and unleash an all-new, beefed-up 6.1-liter 425-horsepower HEMI V-8 engine in the new 2005 Chrysler 300C SRT8. Preliminary performance targets for Chrysler 300C SRT8 are 0-60 mph in the low five-second range and a quarter-mile time in the high 13-second range. The 425-horsepower, naturally aspirated 6.1-liter HEMI will be the highest specific-output V-8 engine ever offered by the Chrysler Group. Its 69.8 horsepower-per-liter rating exceeds even that of the legendary 1966 "Street HEMI." Torque is rated at 420 lb.-ft. "Without question, the HEMI continues to play a critical role in building momentum for the Chrysler Group," said Ridenour. "With the introduction of the 6.1-liter HEMI, we're taking the legendary HEMI to a new level of benchmark performance." Chrysler Group builds HEMI engines at its Saltillo (Mexico) Engine Plant. Production for the 6.1-liter HEMI begins in early 2005. Chrysler Group sales are up three percent year-over-year through November. |
Ads |
#2
|
|||
|
|||
Man those stoopid 8 6 4 engines were a failure way back when. You mean
they have brought them back???? Figures Chrysler would try it.... 'Hemi' used to actually mean something, too bad. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's Luke Smith wrote: > > This is an interesting article. I've heard the HEMI Magnum is a beast, > I would love to get my hands on one of those. > > HEMI's HOT! - Chrysler Finds Winning Formula > AUBURN HILLS, Mich., Dec. 9, 2004; The HEMI(R) continues to build > momentum. Since first introducing the all-new 5.7-liter HEMI V-8 engine > for the 2003 model year, Chrysler Group has sold more than 300,000 > vehicles with a HEMI inside. In Chrysler Group vehicles where HEMI is > offered, the take-rate is 46 percent. > > "The HEMI continues to resonate with consumers and has essentially > become a brand within our brands," said Eric Ridenour, Executive Vice > President, Product Development, Chrysler Group. "And with MDS, our > modern cylinder deactivation system, the HEMI seamlessly moves from > eight cylinders to four cylinders and back. The only thing customers > notice is a savings in fuel economy of up to 20 percent." > > On a product-by-product basis, the HEMI remains a popular engine > choice. For Dodge Durango, the take-rate is 54 percent. The 2005 Dodge > Ram is at 46 percent while Dodge Magnum and Chrysler 300C are at 43 > percent. Jeep(R) Grand Cherokee's take-rate is 29 percent. MDS is > available on Dodge Magnum, Chrysler 300C and Jeep Grand Cherokee. > > In the spring of 2005, Chrysler Group will up the ante and unleash an > all-new, beefed-up 6.1-liter 425-horsepower HEMI V-8 engine in the new > 2005 Chrysler 300C SRT8. Preliminary performance targets for Chrysler > 300C SRT8 are 0-60 mph in the low five-second range and a quarter-mile > time in the high 13-second range. > > The 425-horsepower, naturally aspirated 6.1-liter HEMI will be the > highest specific-output V-8 engine ever offered by the Chrysler Group. > Its 69.8 horsepower-per-liter rating exceeds even that of the legendary > 1966 "Street HEMI." Torque is rated at 420 lb.-ft. > > "Without question, the HEMI continues to play a critical role in > building momentum for the Chrysler Group," said Ridenour. "With the > introduction of the 6.1-liter HEMI, we're taking the legendary HEMI to > a new level of benchmark performance." > > Chrysler Group builds HEMI engines at its Saltillo (Mexico) Engine > Plant. Production for the 6.1-liter HEMI begins in early 2005. Chrysler > Group sales are up three percent year-over-year through November. |
#3
|
|||
|
|||
Don't knock it till you try it...
I've had a hemi Ram 2500 4x4 for one year now. In that year, I've never had to open it up fully! Them 345 horses do a great job of moving that truck along without effort. The dual redundant ignition system adds to reliability (each hole has two plugs, there are eight coils, each coil fires two different cylinders. Except for the truck's turning radius (about 125 ft, IMHO) making it impossible to park in most parking lots, the rig is great. On Fri, 10 Dec 2004 16:31:58 -0500, Mike Romain > wrote: >Man those stoopid 8 6 4 engines were a failure way back when. You mean >they have brought them back???? > >Figures Chrysler would try it.... > >'Hemi' used to actually mean something, too bad. > |
#4
|
|||
|
|||
Too many parts in my opinion.... Wasn't that the last 8 6 4's big
problem? Too many things to screw up. If they run, then great, but if they fail, you need to mortgage the house to fix them.... Mike "Peter D. Hipson" wrote: > > Don't knock it till you try it... > > I've had a hemi Ram 2500 4x4 for one year now. In that year, I've > never had to open it up fully! Them 345 horses do a great job of > moving that truck along without effort. The dual redundant ignition > system adds to reliability (each hole has two plugs, there are eight > coils, each coil fires two different cylinders. > > Except for the truck's turning radius (about 125 ft, IMHO) making it > impossible to park in most parking lots, the rig is great. > > On Fri, 10 Dec 2004 16:31:58 -0500, Mike Romain > > wrote: > > >Man those stoopid 8 6 4 engines were a failure way back when. You mean > >they have brought them back???? > > > >Figures Chrysler would try it.... > > > >'Hemi' used to actually mean something, too bad. > > |
#5
|
|||
|
|||
The GM 8-6-4's problem was GM. They produce garbage and were even worse in
the late 70s to early 80s. My guess is that Chrysler alone wouln't have attempted it, rather the Daimler-Benz people are trying to maintain their reputation for being engineering leaders. I've seen some docs on the web and the new system is more sophisticated, but no, I'm not going to buy one until they've been proven. -John "Mike Romain" > wrote in message ... > Too many parts in my opinion.... Wasn't that the last 8 6 4's big > problem? Too many things to screw up. > > If they run, then great, but if they fail, you need to mortgage the > house to fix them.... > > Mike > > "Peter D. Hipson" wrote: > > > > Don't knock it till you try it... > > > > I've had a hemi Ram 2500 4x4 for one year now. In that year, I've > > never had to open it up fully! Them 345 horses do a great job of > > moving that truck along without effort. The dual redundant ignition > > system adds to reliability (each hole has two plugs, there are eight > > coils, each coil fires two different cylinders. > > > > Except for the truck's turning radius (about 125 ft, IMHO) making it > > impossible to park in most parking lots, the rig is great. > > > > On Fri, 10 Dec 2004 16:31:58 -0500, Mike Romain > > > wrote: > > > > >Man those stoopid 8 6 4 engines were a failure way back when. You mean > > >they have brought them back???? > > > > > >Figures Chrysler would try it.... > > > > > >'Hemi' used to actually mean something, too bad. > > > |
#6
|
|||
|
|||
I think we've come a long way since that previous POS... <g>
That said, I don't think all Hemi's have the cylinder shutdown, I'm not sure mine does... I was mainly trying to say that the engine overall was a winner. I'll have to find out when the MDS (multi-displacement system) was first available... On Fri, 10 Dec 2004 18:18:53 -0500, Mike Romain > wrote: >Too many parts in my opinion.... Wasn't that the last 8 6 4's big >problem? Too many things to screw up. > >If they run, then great, but if they fail, you need to mortgage the >house to fix them.... > >Mike > |
#7
|
|||
|
|||
I think we've come a long way since that previous POS... <g> That said, I don't think all Hemi's have the cylinder shutdown, I'm not sure mine does... I was mainly trying to say that the engine overall was a winner. I'll have to find out when the MDS (multi-displacement system) was first available... 2005 model years. Not even an option in Rams... |
#8
|
|||
|
|||
Takes care of that! <g> Thanks for the enlightenment...
On 12 Dec 2004 16:48:32 GMT, (CHChammer) wrote: > > >2005 model years. Not even an option in Rams... |
#9
|
|||
|
|||
So you can get the HEMI in the magnum but not the 2005 ram?
CHChammer wrote: > I think we've come a long way since that previous POS... <g> > > That said, I don't think all Hemi's have the cylinder shutdown, I'm > not sure mine does... I was mainly trying to say that the engine > overall was a winner. > > I'll have to find out when the MDS (multi-displacement system) was > first available... > > 2005 model years. Not even an option in Rams... |
#10
|
|||
|
|||
On 13 Dec 2004 16:11:19 -0800, "Luke Smith" >
wrote: >So you can get the HEMI in the magnum but not the 2005 ram? > I think he meant the deactivating cylinders option. The hemi has been available in the Ram trucks for a couple of years. Matt 99 V-10 Super Duty, Super Cab 4x4 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS 1953 Hemi Dodge Coronet | Dodge | 0 | October 11th 04 07:33 PM | |
FS: First Year Hemi Dodge | Collector Car Central | Dodge | 2 | August 16th 04 02:04 AM |
'05 Hemi magnum REAL mileage | GRL | Dodge | 16 | June 22nd 04 11:42 PM |