If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1971 454 - 14" 168 tooth flywheel
I have a 1971 454 that has a factory dual disk 10" clutch. I need a 14"
168 tooth flywheel. The available flywheels aren't machined for the 10" clutch. Even if I was able to machine the available flywheel, the available flywheels are too thick and wouldn't fit inside the bellhousing. Do you have any solutions? Thank you very much, Coors Kugeler *** Sent via http://www.automationtools.com *** Add a newsgroup interface to your website today. |
Ads |
#2
|
|||
|
|||
I don't follow what you are saying.
You should be able to get one drilled to mount the 10 inch pressure plate. That isn't a big deal, they usually drill a lot of them for dual sizes. The surface area being smaller than the 11 inch will mean the disk should have no problem fitting. As to too thick, how? I've stuffed a triple disk in before. If all else fails, go to Chevy. "Coors Kugeler" > wrote in message ... > I have a 1971 454 that has a factory dual disk 10" clutch. I need a 14" > 168 tooth flywheel. The available flywheels aren't machined for the 10" > clutch. Even if I was able to machine the available flywheel, the > available flywheels are too thick and wouldn't fit inside the > bellhousing. Do you have any solutions? > > Thank you very much, > Coors Kugeler > > > > *** Sent via http://www.automationtools.com *** > Add a newsgroup interface to your website today. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flywheel? Starter Issue? 1984 - 1987 Accord? Nope! | Daniel J Deyette | Honda | 2 | January 18th 05 03:19 AM |
5.0L Flywheel Positioning | Ironradio | Ford Mustang | 4 | December 5th 04 12:19 AM |
flywheel timing mark | Dick Johnson | Chrysler | 2 | November 22nd 04 01:41 AM |
Flywheel Timing Mark | [email protected] | VW water cooled | 10 | September 22nd 04 12:36 AM |