If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
selespeed stalling
my 156 2000 when stationary-revs drop and often stalls- sometimes revs
race up & down from 2000. bitof a **** when in traffic jams. any ideas/suggestions. |
Ads |
#2
|
|||
|
|||
selespeed stalling
throb wrote:
> my 156 2000 when stationary-revs drop and often stalls- sometimes revs > race up & down from 2000. bitof a **** when in traffic jams. any > ideas/suggestions. Could be the throttle butterfly -- Catman MIB#14 SKoGA#6 TEAR#4 BOTAFOF#38 Apostle#21 COSOC#3 Tyger, Tyger Burning Bright (Remove rust to reply) Alfa 116 Giulietta 3.0l (Really) Sprint 1.7 75 TS 156 TS S2 Triumph Speed Triple: Black with extra black bits www.cuore-sportivo.co.uk |
#3
|
|||
|
|||
selespeed stalling
"throb" > wrote in message lkaboutautos.com... > my 156 2000 when stationary-revs drop and often stalls- sometimes revs > race up & down from 2000. bitof a **** when in traffic jams. any > ideas/suggestions. > I had a car do this once, it was the lambda sensor. |
#4
|
|||
|
|||
selespeed stalling
thanks for your suggestions- can they be done cheaply or an expensive alpha
dealer!? |
#5
|
|||
|
|||
selespeed stalling
On Tue, 02 May 2006 14:48:29 -0400, "throb" >,
wrote: >thanks for your suggestions- can they be done cheaply or an expensive alpha >dealer!? Cost you even more at an Alfa dealer :-) Pete -- > 156 2.0 TS (2001) - Proteo Rosso |
#6
|
|||
|
|||
selespeed stalling
"throb" > wrote in message lkaboutautos.com... > thanks for your suggestions- can they be done cheaply or an expensive > alpha > dealer!? > I bought a universal one for 30 quid from local motor factor. I would have it checked though first, maybe one of those home tune folks would be able to do it. |
#7
|
|||
|
|||
selespeed stalling
throb wrote:
> thanks for your suggestions- can they be done cheaply or an expensive > alpha dealer!? Lambda sensors are cheap and effectively unscrew. Butterfly valve is a bit more involved, but if you can get to it and clean with carb cleaner, it's cheap enough. Other possibilities: Idle actuator as mentioned, can be done in the same way as the throttle I think. -- Catman MIB#14 SKoGA#6 TEAR#4 BOTAFOF#38 Apostle#21 COSOC#3 Tyger, Tyger Burning Bright (Remove rust to reply) Alfa 116 Giulietta 3.0l (Really) Sprint 1.7 75 TS 156 TS S2 Triumph Speed Triple: Black with extra black bits www.cuore-sportivo.co.uk |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
96 Grand Cherokee - Stalling... Replaced CPS .... Different stalling | voodoochild | Jeep | 0 | January 21st 06 03:17 AM |
Serious Rough Idle and stalling on 89 Civic | [email protected] | Honda | 7 | January 18th 06 05:25 PM |
94 Concorde stalling problem | Frans de Wet | Chrysler | 0 | July 1st 05 05:55 AM |
156 Selespeed - Typical Maintenance Requirements | [email protected] | Alfa Romeo | 0 | March 29th 05 05:22 PM |
Prelude stalling problem (picture and movie included !) - need help locating some engine components | Chris | Honda | 1 | March 3rd 05 01:27 AM |