If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
any good plastic replacements in the bay area, CA?
after reading all the different ways folks have changed their back plastic,
I think I'm leaning towards cutting out the plastic, and glueing a new one on. My question is what type of plastic is best to use that you can get from hardware stores. I'm in the san jose, california area - is there anything I should look for from the local hardware stores? are there any plastics that resist yellowing better than others? how about tinting the new plastic - is that possible/helpful??? also, has anyone been able to take out the palstic border that is glued to the top? I was planning to just hot-gluegun the new plastic ontop of the original border once the inside was cut out but I'd rather not have the old yellowed border under the new plastic, and I think the new plastic would adhere better tot he top directly then to the old plastic leftovers... thanks, thomas |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Free for Chicago area user in need. | Tank U | Dodge | 0 | November 29th 04 02:09 AM |
Corvette shop Crestview Florida area: | Process45 | Corvette | 0 | November 5th 04 06:09 PM |
can any good mechanic in west of Boston, MA? | megrp | BMW | 2 | October 26th 04 06:43 PM |
Recommended Mechanics in the Baltimore, Maryland area? | BDWood | Audi | 0 | September 9th 04 11:26 PM |