If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ng for bodywork and refinishing?
Hi there,
I wanted to know if any of you knew of a ng to discuss autobody work, paint, panel retrofits, etc? Is that fair game here? I need advice about how to tackle a bad quarter panel and rocker. I don't know if I should cut one out of a donor car or patch the existing one. The rocker has a fist-sized rusted hole under the door and the rear quarter was mangled a little when the tire flatted on the highway. The car is a 1992 Nissan 240sx that I would like to keep a few more years or more. I assume to pull the whole quarter I would have to drill spot welds, pull the window, bumper, etc... It seems like a lot of work for someone with minimal bodywork experience but I do want to tackle this as a shadetree project. Thanks. Andrew. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wheel refinishing recommendations needed | Richard Cranium | BMW | 13 | March 12th 06 04:37 PM |
Refinishing Question | Jane | General | 2 | September 19th 05 05:57 PM |
Bodywork | Dan Kiehnle | VW air cooled | 0 | March 26th 05 12:32 AM |
Refinishing Vent Wing Frames | Mel P. | VW air cooled | 1 | February 10th 05 05:09 AM |
Refinishing headlight reflectors | Orrin Iseminger | Antique cars | 1 | August 8th 03 01:51 PM |