If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HOLLEY CARB ADJUSTMENT
|
Ads |
#2
|
|||
|
|||
|
#3
|
|||
|
|||
Its a holley 600 cfm with vacum secondary. Performer intake. The only
adjustment screws I see are for the idle and there is one screw on each side of the meetering block up front. Idles fine but stumbles when you get into the throtle. Squirters are working fine. "HAND JOB" > wrote in message ... > DOES ANYBODY KNOW HOW TO ADJUST A HOLLEY 600 CFM CARB? PLEASE RESPOND TO > > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Weber Carb | Phill | BMW | 0 | November 26th 04 12:37 PM |
HOLLEY CARB ADJUSTMENT | HAND JOB | Corvette | 8 | October 19th 04 06:33 PM |
Holley Truck Avenger | Ltine | 4x4 | 0 | August 22nd 04 08:32 PM |
1949 Chevrolet 3100 Truck - How to Identify Carb | Steve | Antique cars | 4 | February 11th 04 12:17 PM |