If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Temp. sending unit location 1966 AMC Ambassador w/ 287 V8
Hi folks,
Does anyone out there know where the temp. sending unit should be located on an AMC 287 block? Just bought this 1966 Amb. and the sending unit is missing and all of the possible block locations are plugged. The problem is that, unless I'm not looking in the right place, the sending unit I got from CarQuest that's supposed to fit this block looks too big for the possible locations where it might go. The sending unit wire is on the left (driver's side) toward the front (fan end) of the block. Thanks for the help, DuNG BeeTLe |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
C1 sending unit float leaking | treetops | Corvette | 4 | October 10th 04 02:34 PM |