If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
would brake fail cause limp-home mode?
I was perusing a dashboard wiring diagram for my jalopy, and noticed that
the brake fail lamp connects not only to the master cylinder switch and lamp check relay, but also to the ECU. Would this be so that the ECU would limit the speed of the car if brakes died? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transmission limp home mode - 96 T&C | Doug | Chrysler | 8 | May 10th 08 09:55 AM |
Limp home mode...96 T&C | Fieronut | Chrysler | 5 | January 20th 07 03:48 AM |
96 T&C in "limp home" mode. Does it need a lot or a little? | Fieronut | Chrysler | 5 | October 19th 06 03:28 PM |
BMW L6 into limp mode with no tach | dkraaf | BMW | 1 | May 14th 06 07:15 PM |
Transmission limp mode | rkm | Dodge | 12 | October 15th 04 12:49 AM |