If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
93 Cherokee Emergency brake lever
This evening the release button and the spring underneath it popped off
the end of the emergency brake lever. Problem is, it popped off as I was setting the brake. Now, I don't have a way to release the brake! The brake is set and I am more-or-less stuck. Fortunately, it happened at the top of the driveway. My question: is there a way to release the emergency brake without using the brake lever? As I look into the space where the button should be located, I see a metal rod, but it is flush inside the housing where the button used to be located. I did try pressing the rod with the tip of a screwdriver, but it does not move. Any suggestions would be most appreciated. |
Ads |
#2
|
|||
|
|||
93 Cherokee Emergency brake lever
There should be an threaded coupler where the main cable splits off to the
right and left side. Back the nut off until the brakes are released. If you send an e-mail I can forward the lever removal instructions. "flydog" > wrote in message oups.com... > This evening the release button and the spring underneath it popped off > the end of the emergency brake lever. Problem is, it popped off as I > was setting the brake. Now, I don't have a way to release the brake! > > The brake is set and I am more-or-less stuck. Fortunately, it happened > at the top of the driveway. My question: is there a way to release the > emergency brake without using the brake lever? As I look into the space > where the button should be located, I see a metal rod, but it is flush > inside the housing where the button used to be located. I did try > pressing the rod with the tip of a screwdriver, but it does not move. > > Any suggestions would be most appreciated. > |
#3
|
|||
|
|||
93 Cherokee Emergency brake lever
flydog did pass the time by typing:
> This evening the release button and the spring underneath it popped off > the end of the emergency brake lever. Problem is, it popped off as I > was setting the brake. Now, I don't have a way to release the brake! > > The brake is set and I am more-or-less stuck. Fortunately, it happened > at the top of the driveway. My question: is there a way to release the > emergency brake without using the brake lever? As I look into the space > where the button should be located, I see a metal rod, but it is flush > inside the housing where the button used to be located. I did try > pressing the rod with the tip of a screwdriver, but it does not move. > > Any suggestions would be most appreciated. If you can get back to the ass end of that handle there is a pawl that catches. Just release the pawl and you can release the brake. -- DougW |
#4
|
|||
|
|||
93 Cherokee Emergency brake lever
An exploded view, may give you an idea:
http://www.billhughes.com/temp/parkLever.pdf God Bless America, Bill O|||||||O flydog wrote: > > This evening the release button and the spring underneath it popped off > the end of the emergency brake lever. Problem is, it popped off as I > was setting the brake. Now, I don't have a way to release the brake! > > The brake is set and I am more-or-less stuck. Fortunately, it happened > at the top of the driveway. My question: is there a way to release the > emergency brake without using the brake lever? As I look into the space > where the button should be located, I see a metal rod, but it is flush > inside the housing where the button used to be located. I did try > pressing the rod with the tip of a screwdriver, but it does not move. > > Any suggestions would be most appreciated. |
#5
|
|||
|
|||
93 Cherokee Emergency brake lever
That's pretty challenging without removing the center console. I don't
know how to do that yet... but I will.... |
#6
|
|||
|
|||
93 Cherokee Emergency brake lever
I believe you will have to lift up on the handle lever before you try
pushing in on that bar. That bar will be held solid by the pressure on the cables. Other than that you can go under and 'try' to take apart the cable setup connection just in front of the back wheels. 'If' you can loosen it, it would make it easier to pull up on the handle to push that rod in. That cable adjustment is usually rusted up solid though. It is only used when installing new cables so it seizes up. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's Canadian Off Road Trips Photos: Non members can still view! Jan/06 http://www.imagestation.com/album/pi...?id=2115147590 (More Off Road album links at bottom of the view page) flydog wrote: > > This evening the release button and the spring underneath it popped off > the end of the emergency brake lever. Problem is, it popped off as I > was setting the brake. Now, I don't have a way to release the brake! > > The brake is set and I am more-or-less stuck. Fortunately, it happened > at the top of the driveway. My question: is there a way to release the > emergency brake without using the brake lever? As I look into the space > where the button should be located, I see a metal rod, but it is flush > inside the housing where the button used to be located. I did try > pressing the rod with the tip of a screwdriver, but it does not move. > > Any suggestions would be most appreciated. |
#7
|
|||
|
|||
93 Cherokee Emergency brake lever
Send me an e-mail for an e-address that can receive attachments and remind
me what info you are looking for.. (remember to remove the SPAM) "flydog" > wrote in message oups.com... > That's pretty challenging without removing the center console. I don't > know how to do that yet... but I will.... > |
#8
|
|||
|
|||
93 Cherokee Emergency brake lever
I was able to back the nut off and relieve the tension. The car now is
drivable. Next job is to replace the lever. |
#9
|
|||
|
|||
93 Cherokee Emergency brake lever
Mister know it all, looks like you spread crap everywhere,
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Emergency Brake on 85 Chevy S10 Pickup | Misty | Technology | 3 | March 22nd 06 06:31 PM |
Emergency Brake Dragging? | Ted | Ford Explorer | 1 | June 18th 05 06:00 AM |
Soft brake persists after Brake Fluid Flush. | [email protected] | Honda | 12 | June 18th 05 02:29 AM |
emergency brake | DD | Mazda | 2 | April 3rd 05 06:24 AM |
Emergency brake problems Audi 100 2,8 V6 | Paw H. Jensen | Audi | 1 | March 20th 05 09:56 AM |