If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
ignition hard to turn
It's an older Chevy. Occasionally the key didn't want to turn, but enough jiggling and I could get it to start.
Now it's every time, and I'm never sure I'll get it. Would spraying lubricant into the keyhole help, or make it worse? |
Ads |
#2
|
|||
|
|||
ignition hard to turn
Tim R > wrote in
: > It's an older Chevy. Occasionally the key didn't want to turn, but > enough jiggling and I could get it to start. > > Now it's every time, and I'm never sure I'll get it. > > Would spraying lubricant into the keyhole help, or make it worse? > it wont hurt anything but dont expect it to help much. the key may be wore out or the tumbler cyl is. but try the lub first. KB ps if you have another key try it first. |
#3
|
|||
|
|||
ignition hard to turn
Tim R wrote:
>It's an older Chevy. Occasionally the key didn't want to turn, but enough jiggling and I could get it to start. > >Now it's every time, and I'm never sure I'll get it. > >Would spraying lubricant into the keyhole help, or make it worse? Better to use powdered graphite (or a dry lube stick) applied directly to the key. -- John H |
#4
|
|||
|
|||
ignition hard to turn
On Saturday, August 11, 2018 at 5:58:27 PM UTC-4, John_H wrote:
> Tim R wrote: > > >It's an older Chevy. Occasionally the key didn't want to turn, but enough jiggling and I could get it to start. > > > >Now it's every time, and I'm never sure I'll get it. > > > >Would spraying lubricant into the keyhole help, or make it worse? > > Better to use powdered graphite (or a dry lube stick) applied directly > to the key. > > -- > John H I'm wary of powdered graphite. Sometimes it can cake into dried mud. I tried all three keys. All have the same problem. It acts like when the steering wheel is in the wrong position, preventing the key from turning. But if we play with it enough eventually it frees and turns. I put a drop of STP on the key and tried that. It improved the action greatly, when it isn't stuck. It doesn't seem to have reduced the getting stuck. |
#5
|
|||
|
|||
ignition hard to turn
On Monday, August 13, 2018 at 2:44:24 AM UTC-10, Tim R wrote:
> On Saturday, August 11, 2018 at 5:58:27 PM UTC-4, John_H wrote: > > Tim R wrote: > > > > >It's an older Chevy. Occasionally the key didn't want to turn, but enough jiggling and I could get it to start. > > > > > >Now it's every time, and I'm never sure I'll get it. > > > > > >Would spraying lubricant into the keyhole help, or make it worse? > > > > Better to use powdered graphite (or a dry lube stick) applied directly > > to the key. > > > > -- > > John H > > I'm wary of powdered graphite. Sometimes it can cake into dried mud. > > I tried all three keys. All have the same problem. It acts like when the steering wheel is in the wrong position, preventing the key from turning. But if we play with it enough eventually it frees and turns. > > I put a drop of STP on the key and tried that. It improved the action greatly, when it isn't stuck. It doesn't seem to have reduced the getting stuck. You're putting a load on the latch of the steering wheel lock. Rotate the steering wheel until the pressure is relieved and frees up the ignition lock. |
#6
|
|||
|
|||
ignition hard to turn
> You're putting a load on the latch of the steering wheel lock. Rotate the steering wheel until the pressure is relieved and frees up the ignition lock. yep on my antique car I turn the wheel about 2 degrees to the left and then the key moves just fine. Nils K. Hammer |
#7
|
|||
|
|||
ignition hard to turn
On Monday, August 13, 2018 at 10:29:26 PM UTC-4, wrote:
> > You're putting a load on the latch of the steering wheel lock. Rotate the steering wheel until the pressure is relieved and frees up the ignition lock. > > yep on my antique car I turn the wheel about 2 degrees to the left and then > the key moves just fine. > > Nils K. Hammer I've had cars (Fords) where you had to shake the steering wheel when the key locked up like that. If I push on the key, the lock will go in a short distance and then turn to the accessory position. It won't go immediately to start, but once it's in accessory getting it into start is usually quick. I think the lubrication helped, it's sticking less now and turning more easily. I used the same stuff (STP) on the rear view mirror. My wife broke it off - the glue let go from the windshield. When I re-glued it I realized both ball and socket joints were very hard to move, so I put a drop of STP on each and worked them until smooth. It adjusts easily now. |
#8
|
|||
|
|||
ignition hard to turn
On 08/14/2018 08:23 AM, Tim R wrote:
> > I've had cars (Fords) where you had to shake the steering wheel when the key locked up like that. > > If I push on the key, the lock will go in a short distance and then turn to the accessory position. It won't go immediately to start, but once it's in accessory getting it into start is usually quick. I think the lubrication helped, it's sticking less now and turning more easily. > > I used the same stuff (STP) on the rear view mirror. My wife broke it off - the glue let go from the windshield. When I re-glued it I realized both ball and socket joints were very hard to move, so I put a drop of STP on each and worked them until smooth. It adjusts easily now. > Hello, and while I can't add/refute anything to the responses to the OP I wanted to add that I've found silicone spray to be an excellent lubricant for tight lock cylinders and keyways and it doesn't cake up like graphite. The other plus is that one application lasts quite a while. Sincerely, -- J. B. Wood e-mail: |
#9
|
|||
|
|||
ignition hard to turn
Follow-up: the small amount of STP must have eventually worked its way through the lock, and now we're having no issues.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
key in ignition.....won`t turn. | Mason121 | Saturn | 8 | March 31st 07 11:09 PM |
Key will not turn in ignition | Jim[_22_] | Chrysler | 2 | February 18th 07 02:58 PM |
Hard to turn left | bokuglen | VW air cooled | 6 | July 17th 06 10:13 AM |
Can't turn ignition key | ge-o | Technology | 4 | May 11th 06 10:19 PM |
'99 Concorde ignition key won't turn | postscript | Chrysler | 8 | September 9th 05 02:45 AM |