If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
LOCKING HEADER BOLT SYSTEM
Hi,
I have not used these, but need to get one out. do I take clip out, then use hex drive to get bolt out ? mustang 5.0 |
Ads |
#2
|
|||
|
|||
LOCKING HEADER BOLT SYSTEM
"chuck" > wrote in message ... > Hi, > > I have not used these, but need to get one out. > do I take clip out, then use hex drive to get bolt out ? > > mustang 5.0 > The ones I am familiar with consist of 3 pieces. The bolt, a crescent-shaped piece and a c-clip. After removing the clip and the crescent shaped piece, the bolt is removed by whichever means works best. I've seen both hex-drive and standard sockets used on these. HTH -- John C. '03 Cobra convt. '00 Cobra R |
#3
|
|||
|
|||
LOCKING HEADER BOLT SYSTEM
"John C." > wrote in message ... > > "chuck" > wrote in message > ... >> Hi, >> >> I have not used these, but need to get one out. >> do I take clip out, then use hex drive to get bolt out ? >> >> mustang 5.0 >> > > The ones I am familiar with consist of 3 pieces. The bolt, a > crescent-shaped piece and a c-clip. After removing the clip and > the crescent shaped piece, the bolt is removed by whichever means > works best. I've seen both hex-drive and standard sockets used on > these. > > HTH > > -- > John C. > '03 Cobra convt. > '00 Cobra R > > Thanks, what is a good way to remove c clip ? small screwdriver and twist in space in slot ? (can't see the c-clip much at all, and perhaps 4 inches of working room, one handed from topside) |
#4
|
|||
|
|||
LOCKING HEADER BOLT SYSTEM
"chuck" > wrote in
: > > Thanks, > what is a good way to remove c clip ? > small screwdriver and twist in space in slot ? > (can't see the c-clip much at all, and perhaps 4 inches of working > room, one handed from topside) > > Screwdriver works just fine. -- John C. '03 Cobra convt. '00 Cobra R |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
busted header bolt | j[_6_] | Jeep | 6 | September 14th 07 12:39 PM |
header bolt | j[_6_] | Jeep | 30 | July 7th 07 03:56 AM |
header bolt | L.W. \(Bill\) Hughes III[_203_] | Auto Photos | 0 | July 4th 07 09:40 AM |
header bolt | L.W. \(Bill\) Hughes III[_198_] | Auto Photos | 0 | July 4th 07 05:06 AM |
header bolt (Nothing to say of any relevance, just C&P Crap) | L.W. \(Bill\) Hughes III[_193_] | Auto Photos | 0 | July 4th 07 03:18 AM |