If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
96 Land Rover Discovery : Diagnosing High Pitched Squeal Wheel Noise ???
I recently purchased an immaculate 96 Land Rover Discovery Series 1
from the original owner. I noticed right from the beginning that occassionally I would hear a high pitched squeal coming from what sounds like either the left front or rear wheel. My initial thought was it was a bad wheel bearing but then I noticed it typically started when I had been braking and then let off the break which led me to believe it might be a metallic sensor on the pad that drags against the caliper (I had an old BMW with this feature). I read that you could diagnose a bad wheel bearing by excessive play in the wheel when jacked up so I jacked the rover up yesterday and tried to see if the wheel moved any direction other than forwards/backwards, seemed pretty solid to me. So then I pulled the wheel and looked at the brakes, they look to be atleast 50% so I don't think it's a brake issue although I have been noticing quite a bit of brake dust on the front wheels, perhaps this is just common of Discovery's? I repeated this process for both left front and rear wheels and didn't notice anything abnormal. While spinning the wheel w/ it jacked up, there is a slight scraping/friction noise but I'm guessing this is normal?? So now I don't know what direction to take on diagnosing this issue. Perhaps I could be way off w/ the source of the noise as it's difficult to pinpoint while driving. It seems to occur at all speeds and doesn't change in volume although there is a slight change in rhythm as if it is related to something that is rotating. Any thoughts on common sources of this problem, what else I could look at etc? I assume it could still be a wheel bearing and seems pretty likely but I can't prove it without prying the wheel apart. I took some pictures of the rotors w/ caliper and the amount of brake pad left if it's worth anything. I've done brakes many times before and I can't imagine the pads are too low, they were replaced about 20k miles ago according to the records I got from the original owner. Any advice would be much appreciated. Thanks in advance... Zach |
#3
|
|||
|
|||
Thanks Kezoe, this seems pretty reasonable given the amount of brake
dust I've been noticing on the front wheels. I've definitely noticed it get worse or start squealing around turns. As for correcting this problem, any recommendations on how to go about cleaning the caliper? I don't have access to an air hose but I do have compressed air that I can use and I assume I could use some chemical brake cleaning products. Any good resources for ordering Land Rover parts online? I'm fairly new to these trucks but I'm really starting to get attached to the vehicle. Thanks again. Zach (kezoe) wrote in message . com>... > Zach, > > I suggest you investigate the brake caliper itself. It sounds like it > is sticking that's why you can here the squealing after braking. The > caliper does not retract far enough and the pads are touching the > disc. This produces a squealing sound. Sometimes it will be worse on > cornering as the stress from a cornering wheel creates movement on the > disc. > > This is common and appears after new pads have done some miles. When > the pads were fitted the pistons were pushed back road dust and all > instead of being cleaned with an air line or something similar. Over > time as the brakes are used, the dust builds up on the caliper piston > seals and causes the sticking. Also, renew the pad fixing kit (little > bars and split pins). As these too, corrode preventing movement of the > pads. > > (Zach Bower) wrote in message . com>... > > I recently purchased an immaculate 96 Land Rover Discovery Series 1 > > from the original owner. I noticed right from the beginning that > > occassionally I would hear a high pitched squeal coming from what > > sounds like either the left front or rear wheel. My initial thought > > was it was a bad wheel bearing but then I noticed it typically started > > when I had been braking and then let off the break which led me to > > believe it might be a metallic sensor on the pad that drags against > > the caliper (I had an old BMW with this feature). I read that you > > could diagnose a bad wheel bearing by excessive play in the wheel when > > jacked up so I jacked the rover up yesterday and tried to see if the > > wheel moved any direction other than forwards/backwards, seemed pretty > > solid to me. So then I pulled the wheel and looked at the brakes, > > they look to be atleast 50% so I don't think it's a brake issue > > although I have been noticing quite a bit of brake dust on the front > > wheels, perhaps this is just common of Discovery's? > > > > I repeated this process for both left front and rear wheels and didn't > > notice anything abnormal. While spinning the wheel w/ it jacked up, > > there is a slight scraping/friction noise but I'm guessing this is > > normal?? > > > > So now I don't know what direction to take on diagnosing this issue. > > Perhaps I could be way off w/ the source of the noise as it's > > difficult to pinpoint while driving. It seems to occur at all speeds > > and doesn't change in volume although there is a slight change in > > rhythm as if it is related to something that is rotating. Any > > thoughts on common sources of this problem, what else I could look at > > etc? I assume it could still be a wheel bearing and seems pretty > > likely but I can't prove it without prying the wheel apart. > > > > I took some pictures of the rotors w/ caliper and the amount of brake > > pad left if it's worth anything. I've done brakes many times before > > and I can't imagine the pads are too low, they were replaced about 20k > > miles ago according to the records I got from the original owner. Any > > advice would be much appreciated. > > > > Thanks in advance... > > > > Zach |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |