If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Column Lock Recall
I would like to get the CLB for my 04 Z06 but after reading installation
instructions am a little scared of removing the panels where it says sounds like breaking when removing as they say that is the hardest part. "C5" > wrote in message ... > > Gerd Henjes > wrote in message > .. . > > Folks, if you have a 6-speed, get a column lock bypass. I did one on my > '97 > > and within a week of getting my '04 Z-06. > > > > It also cures the problem on the automatic without a dealer visit. > > > > Consider what they may screw or scrape up and if your time isn't worth > > something. > > > > Forget about the recall nosense. > > > > Gerd > > Fine, but what is it, can the dealer install it, and if not, who does? > > > > > > > > |
Ads |
#2
|
|||
|
|||
In article >,
"C5Guy" > wrote: > Can someone please post the recall notice information. I am in the UK and I > have not got one and I don't know if I will. > > Many thanks The following is a partial of the notice Product Safety - Electronic Column Lock System #04006A - (Jul 26, 2004) 04006A -- Electronic Column Lock System 1997-2004 Chevrolet Corvette Equipped with a Manual Transmission 1997-2000 Chevrolet Corvette Equipped with an Automatic Transmission 2001-2004 Chevrolet Corvette Equipped with an Automatic Transmission - European Export Only THIS BULLETIN CANCELS AND REPLACES BULLETIN 04006, ISSUED APRIL 2004. ADDITIONAL VEHICLES HAVE BEEN ADDED TO THE POPULATION. THIS BULLETIN DOES NOT INCLUDE A SERVICE PROCEDURE FOR 1997 MANUALS AND EXPORT AUTOMATICS, OR 1998 MANUALS AND EXPORT AUTOMATICS BUILT THROUGH 5/25/98. THE BULLETIN WILL BE REVISED WHEN PARTS FOR THESE VEHICLES ARE AVAILABLE. ALL COPIES OF BULLETIN 04006 SHOULD BE DESTROYED. Condition General Motors has decided that a defect, which relates to motor vehicle safety, exists in certain 1997-2004 model year Chevrolet Corvette vehicles. When you remove the ignition key, the electronic column lock (ECL) system prevents turning of the steering wheel. When the vehicle is started, it unlocks the steering. Two conditions can prevent steering while the vehicle is moving: The vehicle is designed so that if the column fails to unlock when the vehicle is started, the fuel supply will be shut off if the driver tries to move the vehicle. If voltage at the powertrain control module is low or interrupted, however, the fuel shut off may not occur and the vehicle can be accelerated while the steering is locked. During quick cranks, the ECL lock pin may not withdraw fully and, in vehicles where there is abnormally low clearance to the lock plate, there may be contact between the pin and lock plate. This can cause a noise or ratcheting when the steering wheel is turned, or if there is insufficient clearance, the steering wheel cannot be turned. If one of these conditions occurs, a crash could occur without warning. Correction Dealers are to remove the column lock plate on U.S. and Canadian vehicles equipped with an automatic transmission. After the service correction, the steering column will no longer lock when the key is removed. On vehicles equipped with a manual transmission, and export vehicles equipped with an automatic transmission, dealers are to 1) reprogram the PCM, and 2) verify there is adequate lock plate clearance and, if necessary, replace the lock plate. After the service correction, the steering column will continue to lock when the key is removed. Vehicles Involved Involved are certain 1997-2004 model year Chevrolet Corvettes equipped with a manual transmission |
#3
|
|||
|
|||
C5 wrote: > There is supposed to be a "bypass" available aftermarket for the manual > transmissions. Anybody have one in? Can the dealer install it? Does it > void warranty coverage? My new C5 has about 800 miles on it, and no > problem so far, but I understand that the problem was NEVER fixed by GM on > ANY C5s, including the ones built in the last month of production. Is that > accurate information? > A warranty claim can only legally be denied if a modification to your car caused the problem that you want fixed under warranty. I installed the bypass in less than a half hour using the simple instructions that came with it. The C5's with manual transmissions are not actually fixed in the recall- they just set up the computer so the engine won't run if the column locks up. Get the bypass. http://tinyurl.com/59hva |
#4
|
|||
|
|||
Stephen Rabinowitz > I would like to get the CLB for my 04 Z06 but after reading installation > instructions am a little scared of removing the panels where it says sounds > like breaking when removing as they say that is the hardest part. There is nothing hard about it. If you are capable of following simple instructions you can easily do it in less than 30 minutes. |
#5
|
|||
|
|||
Why can't some people read plain english? Gerd
"Jon" > wrote in message ... > > > C5 wrote: > > > > There is supposed to be a "bypass" available aftermarket for the manual > > transmissions. Anybody have one in? Can the dealer install it? Does it > > void warranty coverage? My new C5 has about 800 miles on it, and no > > problem so far, but I understand that the problem was NEVER fixed by GM on > > ANY C5s, including the ones built in the last month of production. Is that > > accurate information? > > > > A warranty claim can only legally be denied if a modification to your > car caused the problem that you want fixed under warranty. > I installed the bypass in less than a half hour using the simple > instructions that came with it. The C5's with manual transmissions are > not actually fixed in the recall- they just set up the computer so the > engine won't run if the column locks up. Get the bypass. > > http://tinyurl.com/59hva > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Another recall!! | Vijay | BMW | 1 | December 31st 04 04:22 AM |
M3: higher idle RPM after service recall | visitor | BMW | 12 | December 3rd 04 01:41 PM |
B5 Recall ? | ronny | Audi | 18 | October 1st 04 01:40 AM |
98 740 fails smog, needs new chip?, factory recall?? Petaluma | Brian Hardy | BMW | 0 | September 18th 04 02:31 AM |
97-99 A6 Was this recall serious ? | Stuart | Audi | 6 | August 4th 04 08:54 AM |