If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
'99 Audi A6 Quattro
I have a '99 Audi A6 Quattro with 75k that is rattling in the front when I
go over bumps...any ideas? |
Ads |
#2
|
|||
|
|||
On Wed, 22 Jun 2005 10:02:21 -0400, "tracycoach"
> wrote: >I have a '99 Audi A6 Quattro with 75k that is rattling in the front when I >go over bumps...any ideas? Check your control arms and tie rod ends. |
#3
|
|||
|
|||
On Wed, 22 Jun 2005 10:02:21 -0400, "tracycoach" >
wrote: > I have a '99 Audi A6 Quattro with 75k that is rattling in the front when I > go over bumps...any ideas? Control arms -- upper and lower, but the lower ones seem to make more noise when the bushings get worn. -- Jay. (remove dashes for legal email address) |
#4
|
|||
|
|||
I believe it was recalled for that problem.
"Jay Somerset" > wrote in message ... > On Wed, 22 Jun 2005 10:02:21 -0400, "tracycoach" > > wrote: > >> I have a '99 Audi A6 Quattro with 75k that is rattling in the front when >> I >> go over bumps...any ideas? > > Control arms -- upper and lower, but the lower ones seem to make more > noise > when the bushings get worn. > -- > Jay. > (remove dashes for legal email address) |
#5
|
|||
|
|||
Jay Somerset wrote:
> Control arms -- upper and lower, but the lower ones seem to make more > noise when the bushings get worn. Does the facelift (02') version A6 suffer from this problem as well? And when they replace these arms on an A4 or A6, is it fixed for good or will it get back when the new arms got worn? I mean where they able to improve these parts quality and durability or are they replaced with parts of equal (bad) quality? Jone |
#6
|
|||
|
|||
On Fri, 24 Jun 2005 13:55:22 +0200, "Jone Tytlandsvik"
> wrote: >Jay Somerset wrote: >> Control arms -- upper and lower, but the lower ones seem to make more >> noise when the bushings get worn. > >Does the facelift (02') version A6 suffer from this problem as well? >And when they replace these arms on an A4 or A6, is it fixed for good or >will it get back when the new arms got worn? I mean where they able to >improve these parts quality and durability or are they replaced with parts >of equal (bad) quality? I had a track rod end replaced 2 years ago. It had worn out within a year and only 4000 miles. The next one is still OK. Mark. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
'98 audi quattro A8 for $9500. What do you guys think??? | Joe | Audi | 3 | May 25th 05 10:04 PM |
brake pads for 2001 Audi A4 2.8L V6 Quattro | Curtis Newton | Audi | 2 | November 18th 04 03:44 PM |
1988 Audi Quattro 90 -WIndow Issues- NEED HELP | tedz | Audi | 3 | August 30th 04 01:19 PM |
Snow Chains in Audi A6 Quattro | Ascot | Audi | 13 | July 24th 04 05:35 PM |
Audi 100 quattro temp gauge probs | Paul Wickham | Audi | 1 | May 31st 04 04:39 PM |