If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
87 mustang convert still not working
i've got a new pump ,good lines and cylinders,13 to 14volts at the
plug for the pump,and when i try the switch all i still get is the click from the resistors.any suggestions would be appreciated cause i have no ideas left |
Ads |
#2
|
|||
|
|||
87 mustang convert still not working
|
#3
|
|||
|
|||
87 mustang convert still not working
HOW CAN YOU GET 13 VOLTS AT THE PUMP BEFORE YOU FLIP THE SWITCH?
is the pump a standard 3 wire model one wire goes to ground the other two are forward(up) and backward (down) or a two wire ( the current reverses at the relay). either way you shouldn't have power at the pump until the switch is pushed. keep looking |
#4
|
|||
|
|||
87 mustang convert still not working
On Wed, 03 May 2006 15:22:39 GMT, "walt peifer"
> wrote: >HOW CAN YOU GET 13 VOLTS AT THE PUMP BEFORE YOU FLIP THE SWITCH? > >is the pump a standard 3 wire model one wire goes to ground the other two >are forward(up) and backward (down) or a two wire ( the current reverses at >the relay). either way you shouldn't have power at the pump until the switch >is pushed. keep looking > iI have power when the switch is engaged. it is the 3 wire configuration.pull the switch forward one line is hot ,push switch in the other line is hot .this plug is after the relays so its not the relays right? If it were the relays there wouldn't be power after them to the plug |
#5
|
|||
|
|||
87 mustang convert still not working
|
#6
|
|||
|
|||
87 mustang convert still not working
ok if you get reveserving current one wire hot at a time. check to see if
the center wire is supplying a steady ground. do you get 12 plus volts from one wire to center or from the one wire to a known ground? if the plug just before the motor is providing both a 12 volt source and a constant ground without poping fuses the pump motor is bad. even if its "replaced" it could be defective. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
87 GT convert top not working | [email protected] | Ford Mustang | 4 | April 28th 06 02:31 AM |
Greddy E-01 Boost controller / e-manage controller, complete for sale | fssgmeister | Ford Mustang | 3 | March 11th 06 01:55 AM |
Dodge Charger v Ford Magnum / Uk journalists' review | Dori A Schmetterling | Chrysler | 8 | February 21st 06 03:50 AM |
2007 Shelby GT500 Mustang | Dan | Ford Mustang | 30 | March 25th 05 12:35 AM |
Resources | Sunset Sam | Ford Mustang | 1 | February 18th 05 06:17 PM |