A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers » VW air cooled
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Help with Kadron/Solex 40 dual carbs



 
 
Thread Tools Display Modes
  #1  
Old October 15th 04, 04:04 AM
volksbuggydriver
external usenet poster
 
Posts: n/a
Default Help with Kadron/Solex 40 dual carbs

We were rebuilding these carbs and when we out it back together the
acceleration circuit wasn't pumping any gas out of the nozzle. When we
were rebuilding them we removed the little brass cap in the float chamber
and there was a little silver ball and a black plastic plunger. We put it
together with the balls under the black plungers and on one side the
little ball kept falling out a little whole. Does anyone know how it's
supposed to go together?

Thnx

Ads
  #2  
Old October 15th 04, 01:12 PM
Kafertoys
external usenet poster
 
Posts: n/a
Default

>We were rebuilding these carbs and when we out it back together the
>acceleration circuit wasn't pumping any gas out of the nozzle. When we
>were rebuilding them we removed the little brass cap in the float chamber
>and there was a little silver ball and a black plastic plunger. We put it
>together with the balls under the black plungers and on one side the
>little ball kept falling out a little whole. Does anyone know how it's
>supposed to go together?
>
>Thnx


If its a rael problem try A.J. Simms at http://lowbugget.com/ hes the expert on
kadrons.

Mario
  #3  
Old October 16th 04, 08:31 PM
Richard Hedd
external usenet poster
 
Posts: n/a
Default

The balls go under the brass squirter tubes.



volksbuggydriver wrote:

> We were rebuilding these carbs and when we out it back together the
> acceleration circuit wasn't pumping any gas out of the nozzle. When we
> were rebuilding them we removed the little brass cap in the float chamber
> and there was a little silver ball and a black plastic plunger. We put it
> together with the balls under the black plungers and on one side the
> little ball kept falling out a little whole. Does anyone know how it's
> supposed to go together?
>
> Thnx
>

 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
E36 Digital Dual Zone Climate Control Repairs Mark D BMW 0 December 8th 04 12:13 AM
SU Carb's for MGA on eBay Mike Fisher Antique cars 0 April 28th 04 03:49 AM
1969 Fairlane Dual Exhaust Rob N Antique cars 1 April 21st 04 12:47 AM
Dual Rear Wheel, 4X4 & Snow Chains OrygunGuy 4x4 0 December 22nd 03 05:05 PM


All times are GMT +1. The time now is 02:04 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright 2004-2021 AutoBanter.
The comments are property of their posters.