If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
99 Taurus SHO
I have a 99 Taurus SHO with 58,000 miles and recently have noticed a
ticking noise at idle. I know this is overhead cam but are they similar to other cars with hydraulic lifters? Could it be a bent pushrod or something? Hurc, any idea what this is? I'm stumped... Roger |
Ads |
#2
|
|||
|
|||
On Tue, 03 May 2005 22:28:57 -0500, Roger Raines >
wrote: >I have a 99 Taurus SHO with 58,000 miles and recently have noticed a >ticking noise at idle. I know this is overhead cam but are they similar to >other cars with hydraulic lifters? Could it be a bent pushrod or >something? Hurc, any idea what this is? I'm stumped... > >Roger prolly normal injector noise go to lot and listen to another motor use a long screwdriver put handle to ear and tip on various areas of engine to try to isolate overhead cam rules out bent pushrods as well as u dident mention a miss hurc ast |
#3
|
|||
|
|||
OHC has no pushrods or lifters. Is your oil full? When was it last changed?
Carl "Roger Raines" > wrote in message ... > I have a 99 Taurus SHO with 58,000 miles and recently have noticed a > ticking noise at idle. I know this is overhead cam but are they similar to > other cars with hydraulic lifters? Could it be a bent pushrod or > something? Hurc, any idea what this is? I'm stumped... > > Roger |
#4
|
|||
|
|||
On Tue, 3 May 2005 21:04:59 -0700, "Carl Saiyed"
> wrote: >OHC has no pushrods or lifters. Is your oil full? When was it last changed? > >Carl > > > a piston has colapsed lmfao i like gravey hurc ast |
#5
|
|||
|
|||
In article >,
Roger Raines > wrote: > I have a 99 Taurus SHO with 58,000 miles and recently have noticed a > ticking noise at idle. I know this is overhead cam but are they similar to > other cars with hydraulic lifters? Could it be a bent pushrod or > something? Hurc, any idea what this is? I'm stumped... > > Roger Yea, it's a bent pushrod, fer sher. Common problem in Yamaha DOHC engines. Take it to your local Ford Service Department and have a Certified Master Technician replace it immediately. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
'97 Taurus OD quit | ProudPapa | Technology | 5 | January 16th 05 10:23 AM |
Moisture inside the windows of our '96 Ford Taurus | [email protected] | Technology | 4 | January 11th 05 04:30 PM |
89 Taurus V6 Problem | F. Dail Singleton, Jr. | Technology | 6 | January 8th 05 05:48 PM |
ford taurus 2000 sel. white rims available? xenon hids bad for taurus? | Lucky No One | General | 1 | May 14th 04 09:56 PM |
Tempo & Taurus Are They Good Cars. | Denny B | General | 2 | January 14th 04 03:42 PM |