If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
94 V6 Lebaron - Timing Belt
At 112k miles with an original water pump and timing belt, any suggestions
as whether they should be replaced soon or can I wait until one goes? I'm guessing when the timing belt goes on an older Chrysler, it doesn't take out the engine as it can with (as an example) typical Honda vehicles where replacement is highly recommended around 110k miles. When it goes, does the car simply stop running? The car is now primarily used around town, perhaps up to 30 miles from home & mostly low mileage use primarily in the summer being a convertible. Any comments? |
Ads |
#2
|
|||
|
|||
94 V6 Lebaron - Timing Belt
"clamz" > wrote in message ... > At 112k miles with an original water pump and timing belt, any suggestions > as whether they should be replaced soon or can I wait until one goes? I'm > guessing when the timing belt goes on an older Chrysler, it doesn't take > out the engine as it can with (as an example) typical Honda vehicles where > replacement is highly recommended around 110k miles. When it goes, does > the car simply stop running? The car is now primarily used around town, > perhaps up to 30 miles from home & mostly low mileage use primarily in the > summer being a convertible. > > Any comments? > Follow-up question - apparently the front bearings are sealed, but the rear bearings need to be repacked each 30k miles? |
#3
|
|||
|
|||
94 V6 Lebaron - Timing Belt
change them both and be done with it. cheap insurance. even if the belt is
ok, the tensioner is most likely getting tired. depending on what engine it is, it might be an interference engine or it might not. "clamz" > wrote in message ... > At 112k miles with an original water pump and timing belt, any suggestions > as whether they should be replaced soon or can I wait until one goes? I'm > guessing when the timing belt goes on an older Chrysler, it doesn't take > out the engine as it can with (as an example) typical Honda vehicles where > replacement is highly recommended around 110k miles. When it goes, does > the car simply stop running? The car is now primarily used around town, > perhaps up to 30 miles from home & mostly low mileage use primarily in the > summer being a convertible. > > Any comments? > |
#4
|
|||
|
|||
94 V6 Lebaron - Timing Belt
"Rob" > wrote in message
ng.com... > change them both and be done with it. cheap insurance. even if the belt > is ok, the tensioner is most likely getting tired. > > depending on what engine it is, it might be an interference engine or it > might not. > > Just a shot in the dark here, but the only v6 option for the compacts (Lebaron,Spirit, Acclaim) was the Mitsubishi 3.0. I would never just wait for it to break because sometimes they shear teeth and jump time too. It should have been replaced in '03 IMNSHO just due to age. |
#5
|
|||
|
|||
94 V6 Lebaron - Timing Belt
On 09/01/11 07:43 pm, Daniel who wants to know wrote:
>> change them both and be done with it. cheap insurance. even if the belt >> is ok, the tensioner is most likely getting tired. >> >> depending on what engine it is, it might be an interference engine or it >> might not. >> >> > > Just a shot in the dark here, but the only v6 option for the compacts > (Lebaron,Spirit, Acclaim) was the Mitsubishi 3.0. > > I would never just wait for it to break because sometimes they shear teeth > and jump time too. It should have been replaced in '03 IMNSHO just due to > age. > > And if it's like the 2.5L V6 in our old Stratus ES, when that belt breaks the car's not worth fixing. Perce |
#6
|
|||
|
|||
94 V6 Lebaron - Timing Belt
clamz wrote:
> At 112k miles with an original water pump and timing belt, Wow. You really don't drive it much - do you? > any suggestions as whether they should be replaced soon or can > I wait until one goes? Do you really want to be stuck somewhere, looking at an expensive tow to a service garage, where they'll tell you they can't do it until next thursday? Just based on the age of the belt, combined with the milage, I'd say it's time to replace it. And yes, it's a good time to replace the pump, ider or tensioner, and even a few gaskets or seals in there as well. I did that all that with my '00 300M a year or two ago. > I'm guessing when the timing belt goes on an older Chrysler, it > doesn't take out the engine as it can with (as an example) typical > Honda vehicles where replacement is highly recommended around 110k > miles. When it goes, does the car simply stop running? I have no idea if you engine is an interference type or not. My 3.5L V6 _is_ an interference type - don't know how it differs from your '94 version. |
#7
|
|||
|
|||
94 V6 Lebaron - Timing Belt
"MoPar Man" > wrote in message ... > clamz wrote: > >> At 112k miles with an original water pump and timing belt, > > Wow. You really don't drive it much - do you? Being a convertible, it's gotten babied over the past ten years. I put the top down in April and it's about to go up in October. When it's sunny, it gets driven primarily around the county. Otherwise, it stays in the garage. On the other hand, my 00 Accord just passed 200K and my 05 Pilot just passed 130k. > >> any suggestions as whether they should be replaced soon or can >> I wait until one goes? > > Do you really want to be stuck somewhere, looking at an expensive tow to > a service garage, where they'll tell you they can't do it until next > thursday? Probably should replace it, but now that summer's coming to and end, guess I'll wait til next spring. > > Just based on the age of the belt, combined with the milage, I'd say > it's time to replace it. And yes, it's a good time to replace the pump, > ider or tensioner, and even a few gaskets or seals in there as well. Tensioner was replaced about five years ago along with the external belts when the (aged) brake lines were also replaced. It's actually been a very low maintainence car - almost as good as my Accord (and far superior to any of the GM cars I've owned) and continues to run very well. |
#8
|
|||
|
|||
94 V6 Lebaron - Timing Belt
clamz wrote:
> Tensioner was replaced about five years ago along with the external > belts when the (aged) brake lines were also replaced. Was that an external belt-tensioner? Or was that the timing-belt tensioner (which you can't see unless you take the timing cover off) ? |
#9
|
|||
|
|||
94 V6 Lebaron - Timing Belt
"MoPar Man" > wrote in message ... > clamz wrote: > >> Tensioner was replaced about five years ago along with the external >> belts when the (aged) brake lines were also replaced. > > Was that an external belt-tensioner? > > Or was that the timing-belt tensioner (which you can't see unless you > take the timing cover off) ? My ignorance - I was referring to the serpentine, air conditioner and alternator belts vs. the timing belt. I'm guessing that was an external tensioner for those belts. |
#10
|
|||
|
|||
94 V6 Lebaron - Timing Belt
clamz wrote:
> > Was that an external belt-tensioner? > > > > Or was that the timing-belt tensioner (which you can't see > > unless you take the timing cover off) ? > > My ignorance - I was referring to the serpentine, air conditioner > and alternator belts vs. the timing belt. I'm guessing that was > an external tensioner for those belts. When dealing with the timing belt tensioner, you're going to come across these terms: - tensioner - pulley - hydraulic tensioner - Timing Belt Hydraulic tensioner - damper - timing component kit / roller kit Some of these terms are just different names for the same thing (ie damper might just be another name for tensioner). The tensioner might be 2 or 3 different parts (arm, hydraulic part, pulley) and when you start having some parts guy looking it up, you're going to find that the original part number is superceded to another number, which is superceded to another number, etc. Even with my car (6 years newer than yours) I had that issue about needing a new idler arm to go with a matching pulley or some such nonsense because the original pulley was no longer available. If you go with non-MoPar parts, I think most timing belts come in the form of a kit (belt + pulley / tensioner) as well as belt alone. When it comes to the water pump, again you're going to find that the original P/N is superceded to a newer P/N etc etc and then discontinued, so the ultimate replacement is aftermarket brand. Also, you should have the front-main seal replaced because it's right there and easy to do. It should be cheap ($12) and cost practically no additional labor cost. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to replace water pump and timing belt on 91 lebaron 3.0 v6 | patterson_thomas | Chrysler | 2 | September 27th 06 09:00 AM |
78 VW Rabbit Diesel TIming Belt/Injector Timing Question | JH | VW water cooled | 13 | August 5th 06 02:57 AM |
89 Lebaron Timing Belt... HELP! | Dan Erickson via CarKB.com | Chrysler | 2 | April 16th 05 02:27 AM |
Saturn SL1 1998 - Timing chain or Timing belt ? | CD | Saturn | 1 | November 3rd 04 12:47 AM |
Saturn SL1 1998 - Timing Chain or Timing Belt? | CD | Saturn | 0 | November 3rd 04 12:35 AM |