If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
wheelhouse repair
Hello I am new to this group and I want to say hello.
I am working on a 1965 Mustang Convertible and I am in need of some help. Has anybody out there removed the inner or outer wheelhouse assemblies from there older Mustangs? I have already cut out the spot welds, but, in doing so I noticed there is a seam which is factory pressed and does not allow the two sections to come apart. I don't want to wreck the entire wheelwell trying to separate the two halves. Any suggestions or hints? Cliff |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Scratch repair | Steve | Technology | 3 | April 28th 06 06:48 PM |
Front-End Repair? Maybe Just Throw It Away | Dotcom Computers Ltd | BMW | 0 | October 20th 05 11:02 AM |
Nationwide Crash Repair BEWARE Poor quality repair | Frustrated Car Owner | Technology | 16 | June 14th 05 08:36 PM |
New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |