If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
DRL module
This may apply only to Canadian Miata owners...
I had commented in an earlier discussion on the merits of DRLs, that the left DRL on my 94 would intermittently go out, even though the bulb would flash with the left turn signal. I finally got around to pulling out the DRL module(a light-green plastic module hanging behind the instrument cluster above the brake pedal)... in it is a printed circuit board about 2 inches square, containing a couple of relays and a few transistors diodes resistors etc. Suspecting a cold solder joint, I re-flowed solder on all the connections, and now for more than a week, I consistently have 2 DRLs. maybe this info will help somebody else. Pete |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 7 | February 1st 05 01:43 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 1st 04 05:24 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | October 16th 04 05:28 AM |