If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Rear gear change in '91
I am thinking of swapping the stock 3.08's for 3.55's in my '91 rear
end. A friend told be that it's not a good idea because the gears are normally lapped at the factory and if I replace them, my diff is going to howl. Can anybody comment on this? I am also toying with the idea of replacing the carrier assy. with either a new limited slip or possibly a locker. Is this something the home mechanic should try or am I better off getting a mechanic to do it? Is it simply a tedious thing or does it take special tools? |
#2
|
|||
|
|||
Well.... if your friend replaces the gears, you can expect them to howl....
However, if they are installed properly, there will be no problem. You can either trust your friend or you can trust a mechanic. ne last thing... if you are going to trust a cheap mechanic, you might be better off trusting your friend. There are good mechanics and bad mechanics...... don't even pretend to think that a good mechanic will be happy with bad mehanic wages. "5point0" > wrote in message ... > I am thinking of swapping the stock 3.08's for 3.55's in my '91 rear > end. A friend told be that it's not a good idea because the gears are > normally lapped at the factory and if I replace them, my diff is going to > howl. Can anybody comment on this? > > I am also toying with the idea of replacing the carrier assy. with > either a new limited slip or possibly a locker. Is this something the home > mechanic should try or am I better off getting a mechanic to do it? Is it > simply a tedious thing or does it take special tools? > > |
#3
|
|||
|
|||
I agree with Jim fully. Get it done by a reputable mechanic.. and yes, you
will pay a little more, but it will last. Btw... check www.mustangtuning.com for the gears. Best prices I've seen! -Mike -- A happy kid behind the wheel of a 98 Mustang GT Cold air intake FRPP 3.73 gears Steeda Tri-Ax Shifter Flowmaster 40 Series mufflers (self-installed woohoo) Hi-speed fan switch 255/60R-15 rear tires Subframe connectors Aluminum adjustable clutch quadrant "Jim Warman" > wrote in message news:OEZMd.238$gA4.65@edtnps89... > Well.... if your friend replaces the gears, you can expect them to howl.... > However, if they are installed properly, there will be no problem. You can > either trust your friend or you can trust a mechanic. ne last thing... if > you are going to trust a cheap mechanic, you might be better off trusting > your friend. > > There are good mechanics and bad mechanics...... don't even pretend to think > that a good mechanic will be happy with bad mehanic wages. > > > "5point0" > wrote in message > ... > > I am thinking of swapping the stock 3.08's for 3.55's in my '91 rear > > end. A friend told be that it's not a good idea because the gears are > > normally lapped at the factory and if I replace them, my diff is going to > > howl. Can anybody comment on this? > > > > I am also toying with the idea of replacing the carrier assy. with > > either a new limited slip or possibly a locker. Is this something the > home > > mechanic should try or am I better off getting a mechanic to do it? Is it > > simply a tedious thing or does it take special tools? > > > > > > |
#4
|
|||
|
|||
If is a manual 3.73 you'll be starting off in second normal driving and
dont't think about going over 100 without screaming. If you have the money have drivetrain direct build it for you and ship it. I had one built using 31 spline and no c-clips shipped for $1100. I has been a few years but it was an easy swap that you can do with a friend in you driveway. I asked and they recommended 3.27 if your going to add a blower. Good luck! Hooked 87 |
#5
|
|||
|
|||
If is a manual 3.73 you'll be starting off in second normal driving and
dont't think about going over 100 without screaming. If you have the money have drivetrain direct build it for you and ship it. I had one built using 31 spline and no c-clips shipped for $1100. I has been a few years but it was an easy swap that you can do with a friend in you driveway. I asked and they recommended 3.27 if your going to add a blower. Good luck! Hooked 87 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gear wont change in auto Lebaron GTC 1995 | Airay | Chrysler | 8 | December 22nd 04 04:17 PM |
New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
Gear change and Air Con | Ballymoney | Alfa Romeo | 3 | October 3rd 04 08:40 AM |