|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 27th 08, 03:58 PM
posted to alt.autos.bmw
|
|||
|
|||
320i Lambda Drawing Request
I am trying to adapt the Jetronic lambda controller from a 1983 BMW 320i
into a Mercedes 230CE, a gray market car. This is to an aftermarket controller that has failed. The trouble is that I need a wiring diagram. After many hours searching online, the only one that I can find is not very readable. The color codes that I can read don't match up to the wire harness that I pulled from the 320i. I am hoping that someone can direct me to one online or scan one and post it here. Thanks, Scott 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AWA [OFFER] Rotor Arms, Condensers, Ignition Modules, Distributor Caps and Lambda Senso | [email protected] | General | 0 | March 9th 06 02:51 PM |
| Q:How to check Lambda? | Asus | BMW | 4 | August 21st 05 09:51 PM |
| how can i tell location of lambda sensor b1 s1 ? | blueyo | Audi | 0 | March 5th 05 05:40 PM |
| Catalytic Convertor Lambda Probe | Ian Gaskell | Audi | 0 | May 21st 04 05:14 PM |
Linear Mode
