If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1970 Mach 1 Rocker Panel Covers
I am looking for a set of Rocker Panel Covers for a 1970 Mach 1. I have looked everywhere that I know of and have not found any reproduction sets. I have found a few here and there on ebay, but not a complete set. Does anyone know of any company or manufacturer that is making these ? Or has anyone seen a set for sale ? Thanks, Jim Austin, Tx. |
Ads |
#2
|
|||
|
|||
1970 Mach 1 Rocker Panel Covers
Jim wrote:
> I am looking for a set of Rocker Panel Covers for a 1970 Mach 1. > I have looked everywhere that I know of and have not found any reproduction > sets. > I have found a few here and there on ebay, but not a complete set. > > Does anyone know of any company or manufacturer that is making these ? > Or has anyone seen a set for sale ? > > Thanks, > Jim Austin, Tx. > > I saw a set on a shelf a few years ago here http://www.fordpowerparts.com/ you might get lucky...or not. -- Tropic Green Y2K Mustang GT W/bits & pieces http://tinyurl.com/eh99n |
#3
|
|||
|
|||
1970 Mach 1 Rocker Panel Covers
Good luck. A good pair of these are hard to come by. Keep and eye on e-bay
and expect to spend a bit of green for a good pair of used ones. They may be reproduced someday but there isn't a big demand for them and new one's will still set you back a bucket of cash. -- Mark -- |
#4
|
|||
|
|||
1970 Mach 1 Rocker Panel Covers
As far as I know there are no reproductions - you are going to have to find
used parts. Try Ebay but get ready to pay big time. The following sites feature used and/or NOS parts: http://www.perogie.com http://www.fomoco.com http://www.metromusclecars.com Yet another $.02 worth from a proud owner of a 1970 Mach 1 351C @ http://community.webshots.com/album/18644819fHAehGJAjt "Jim" > wrote in message ... > > I am looking for a set of Rocker Panel Covers for a 1970 Mach 1. > I have looked everywhere that I know of and have not found any > reproduction sets. > I have found a few here and there on ebay, but not a complete set. > > Does anyone know of any company or manufacturer that is making these ? > Or has anyone seen a set for sale ? > > Thanks, > Jim Austin, Tx. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Door stuck shut covers panel screws (how to remove?) | Stuart A. Bronstein | Technology | 0 | February 28th 06 08:22 AM |
Door stuck shut covers panel screws (how to remove?) | Stuart A. Bronstein | Technology | 0 | February 26th 06 09:07 AM |
1998 Windstar Instrument Panel Light Bulb Replacement Procedure Question | KC | Technology | 0 | February 8th 06 02:20 AM |
factory rocker panel guards | tjce | Jeep | 0 | February 1st 06 07:01 PM |
Pics of the 2005 Mustang with a 1970 Mach 1 | Grover C. McCoury III | Ford Mustang | 12 | March 20th 05 07:05 PM |