|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 27th 05, 12:33 AM
|
|||
|
|||
Durango axle question - 8.25 vs 9.25
Looking at the Dodge web site, the 'build your Durango' part refers to a
choice of a 'Corporate 8.25' vs. a 'Corporate 9.25 LD' rear axle. Can someone explain? I know about gear ratios, but this is a separate item. Is it the size of the axle, and therefore the weight-bearing capacity? 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dana 44 axle bearing question | Timmy 4x4 | Jeep | 2 | August 3rd 05 06:57 PM |
| rear axle question | Dane Tyler | VW air cooled | 4 | July 1st 05 04:30 AM |
| Dana 44 - 30 spline axle question | JeePenn | Jeep | 6 | May 14th 05 09:44 PM |
| GM 12 bolt axle bearings question | [email protected] | Technology | 2 | May 4th 05 03:28 AM |
| 94 Caprice 9C1 police rear axle bearing question | [email protected] | Technology | 9 | April 17th 05 03:43 PM |
Linear Mode
