If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Accord TCU
Hi all,
I have a 91 Accord DX, and I want to replace its Transmission Control Unit. I bought the tools to remove the steel plate (under the passanger side carpet) to which the TCU is attached. But I now notice that the nuts which are used to attach the TCU to the steel plate seem to be welded onto the plate. So I am not able to turn these nuts. How can I detach the TCU from that steel plate? Thank you, Fijoy |
Ads |
#2
|
|||
|
|||
Accord TCU
Fijoy wrote:
> How can I detach the TCU from that steel plate? I think my Prelude mounting is similar to your Accord configuration. You have to unfasten the plate from the floorboard and turn it over to get access to the mounting bolts. They thread into the nuts that you see. It helps to disconnect some of the cables that attach to the transmission control computer and the engine control computer. Getting the plate and the computers out takes some contortion. Once it's out of the car you'll have easy access to the four mounting bolts of the TCU. -- Chuck |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
95 Accord Oil Pan | [email protected] | Honda | 2 | August 8th 07 02:46 PM |
radical Honda Accord conversion............"Airplane Accord" | Hans | Driving | 0 | July 15th 06 03:26 PM |
radical Honda Accord conversion............"Airplane Accord" | Hansi | Honda | 0 | July 15th 06 03:23 PM |
Accord Sat Nav | David B | Honda | 1 | April 9th 06 09:29 AM |
accord 93 | seinlys | Honda | 2 | November 17th 04 11:10 PM |