If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Vibration in 99 SL1 when running in gear at stop.
My 1999 SL1 has a very loud vibration coming from the engine compartment
when it is running and in gear and standing still. If I shift it into Park the vibration stops. When you begin moving it stops. It is only when you are running and in gear and stopped that the vibration is felt and heard (at a stop light for example). Any ideas where to look for this problem? |
Ads |
#2
|
|||
|
|||
reex01 > wrote:
> (at a stop light for example). Any ideas where to look for this problem? Motor mount? -DanD -- # Dan Duncan (kd4igw) http://pcisys.net/~dand # There's more than one way to skin a cat. # Method #92: kerosene and a Zippo |
#3
|
|||
|
|||
On Sun, 23 Jan 2005 11:28:37 -0500, "reex01" >
wrote: >My 1999 SL1 has a very loud vibration coming from the engine compartment >when it is running and in gear and standing still. If I shift it into Park >the vibration stops. When you begin moving it stops. It is only when you >are running and in gear and stopped that the vibration is felt and heard >(at a stop light for example). Any ideas where to look for this problem? Motor mount. Had same thing on 98 SL2. |
#4
|
|||
|
|||
I'd guess motor mount.
Don't know about the '99's, but the upper torque mount on my '94 was a piece of cake to fix. You just have to make sure you support the engine when you take the thing off...a floor jack perhaps. I used a long 2x2 I could stand on to support the engine and "wiggle" it into place as I replace the mount. "reex01" > wrote in message lkaboutautos.com... > My 1999 SL1 has a very loud vibration coming from the engine compartment > when it is running and in gear and standing still. If I shift it into Park > the vibration stops. When you begin moving it stops. It is only when you > are running and in gear and stopped that the vibration is felt and heard > (at a stop light for example). Any ideas where to look for this problem? > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Running a stop sign is not speeding | John F. Carr | Driving | 19 | January 19th 05 05:50 PM |
Noise after lift, 97TJ, bump stop shaft & spring? | pbarton | Jeep | 8 | January 9th 05 09:16 PM |
Speedo gear problem | Jeff Scherb | Jeep | 2 | December 19th 04 11:57 AM |
No reverse gear on 2000 Saturn SL2 A/T | 2000SaturnSL2 | Saturn | 6 | October 6th 04 06:18 PM |