|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 16th 07, 12:18 AM
posted to alt.autos.toyota,rec.autos.tech
|
|||
|
|||
Jack stands
By the way, when my Toyota dealer lifts the Camry,
their machine lifts at the 4 sets of notches found on the side rails by each wheel ;-) 
|
| Ads |
|
#2
October 16th 07, 03:34 AM
posted to alt.autos.toyota,rec.autos.tech
|
|||
|
|||
|
Jack stands
"Built_Well" > wrote in message anews.com... > By the way, when my Toyota dealer lifts the Camry, > their machine lifts at the 4 sets of notches > found on the side rails by each wheel ;-) Lifting straight up from 4 points doesn't damage the pinch weld, but using a floor jack, which moves in an arc, can. -- Ray O (correct punctuation to reply)
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jack stands | Built_Well | Technology | 11 | October 16th 07 08:24 PM |
| jack stands w/ flat saddle? | Nate Nagel[_2_] | Technology | 0 | April 22nd 07 02:38 AM |
| Adapters for jack stands on unibody pinch welds? | [email protected] | Technology | 5 | March 1st 06 03:54 AM |
| El cheapo jack stands recommended? | [email protected] | Technology | 18 | January 31st 06 07:32 PM |
| Who sells 4' tall jack stands? | Dean | Technology | 4 | August 7th 05 12:01 AM |
Linear Mode
