If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
97 Ford Explorer Control Trak
I have a 97 Explorer XLT...
I had Ford replace the engine and transfer case, both junk yard parts and now I can't get it to stay out of 4 wheel auto. It hops when I turn corners and sometimes stops the truck. I removed the front drive shaft to confirm that it was the problem does anyone know if there will be a problem if I leave the front drive axle off?? Thanks, Carl |
Ads |
#2
|
|||
|
|||
Well, your 4WD won't work anymore if you leave it off ;-)
seriously, if this is an issue for you, you could always install manual hubs. Some of us really like them better. It gives us more control over when the 4X4 is engaged or not. Without the hubs engaging, it doesn't make a hill of beans if the X-fer case is engaged or not. The hubs aren't all expensive of an investment in your own peace of mind. "Carl Montgomery" > wrote in message news:vxKLe.2955$%K4.2473@trnddc09... |I have a 97 Explorer XLT... | | I had Ford replace the engine and transfer case, both junk yard parts and | now I can't get it to stay out of 4 wheel auto. It hops when I turn corners | and sometimes stops the truck. | | I removed the front drive shaft to confirm that it was the problem does | anyone know if there will be a problem if I leave the front drive axle | off?? | | Thanks, | Carl | | |
#3
|
|||
|
|||
I can't figure out why you haven't taken it back to Ford to have them put it
back together correctly... -- "Carl Montgomery" > wrote in message news:vxKLe.2955$%K4.2473@trnddc09... > I have a 97 Explorer XLT... > > I had Ford replace the engine and transfer case, both junk yard parts and > now I can't get it to stay out of 4 wheel auto. It hops when I turn corners > and sometimes stops the truck. > > I removed the front drive shaft to confirm that it was the problem does > anyone know if there will be a problem if I leave the front drive axle > off?? > > Thanks, > Carl > > |
#4
|
|||
|
|||
Your symptoms sound like one or more speed sensors in the transfer case are
either gunked up, defective, or not hooked up correctly. Do you get the 4WD lights flashing on the dash? That usually indicates the GEM sees this problem and will disable the 4WD. =Vic= Bear Gap, PA "Carl Montgomery" > wrote in message news:vxKLe.2955$%K4.2473@trnddc09... > I have a 97 Explorer XLT... > > I had Ford replace the engine and transfer case, both junk yard parts and > now I can't get it to stay out of 4 wheel auto. It hops when I turn corners > and sometimes stops the truck. > > I removed the front drive shaft to confirm that it was the problem does > anyone know if there will be a problem if I leave the front drive axle > off?? > > Thanks, > Carl > > |
#5
|
|||
|
|||
Can I get the hubs from the auto parts store?
"John Riggs" > wrote in message news:1124038737.457777f845c8c53d3126125312a6b7e6@b ubbanews... > Well, your 4WD won't work anymore if you leave it off ;-) > > seriously, if this is an issue for you, you could always install manual > hubs. Some of us really like them better. It gives us more control over > when > the 4X4 is engaged or not. Without the hubs engaging, it doesn't make a > hill > of beans if the X-fer case is engaged or not. The hubs aren't all > expensive > of an investment in your own peace of mind. > > > "Carl Montgomery" > wrote in message > news:vxKLe.2955$%K4.2473@trnddc09... > |I have a 97 Explorer XLT... > | > | I had Ford replace the engine and transfer case, both junk yard parts > and > | now I can't get it to stay out of 4 wheel auto. It hops when I turn > corners > | and sometimes stops the truck. > | > | I removed the front drive shaft to confirm that it was the problem does > | anyone know if there will be a problem if I leave the front drive axle > | off?? > | > | Thanks, > | Carl > | > | > > |
#6
|
|||
|
|||
I did... they said it is not their problem and they wired it right. They
said that it was due to the fact that it was a junk yard transfercase. Donley in Galion,OH was not much help after the repair. "Herb Kauhry" > wrote in message ... >I can't figure out why you haven't taken it back to Ford to have them put >it > back together correctly... > > -- > > "Carl Montgomery" > wrote in message > news:vxKLe.2955$%K4.2473@trnddc09... >> I have a 97 Explorer XLT... >> >> I had Ford replace the engine and transfer case, both junk yard parts and >> now I can't get it to stay out of 4 wheel auto. It hops when I turn > corners >> and sometimes stops the truck. >> >> I removed the front drive shaft to confirm that it was the problem does >> anyone know if there will be a problem if I leave the front drive axle >> off?? >> >> Thanks, >> Carl >> >> > > |
#7
|
|||
|
|||
When I first Got it back the 4wd lights did blink for about an hours
flashing some codes and then they stopped. After that the alternator went out. So...Donley told me the 4wd lights were flashing because my alternator was going out...The flashing happened of course before I saw any signs of the alternator. Word to the wise...Fix it yourself if you can!! "Vic Klein" > wrote in message ... > Your symptoms sound like one or more speed sensors in the transfer case > are > either gunked up, defective, or not hooked up correctly. Do you get the > 4WD > lights flashing on the dash? That usually indicates the GEM sees this > problem and will disable the 4WD. > > =Vic= > Bear Gap, PA > > "Carl Montgomery" > wrote in message > news:vxKLe.2955$%K4.2473@trnddc09... >> I have a 97 Explorer XLT... >> >> I had Ford replace the engine and transfer case, both junk yard parts and >> now I can't get it to stay out of 4 wheel auto. It hops when I turn > corners >> and sometimes stops the truck. >> >> I removed the front drive shaft to confirm that it was the problem does >> anyone know if there will be a problem if I leave the front drive axle >> off?? >> >> Thanks, >> Carl >> >> > > |
#8
|
|||
|
|||
Usually.
"Carl Montgomery" > wrote in message news:AB8Me.4698$H_4.2519@trnddc07... | Can I get the hubs from the auto parts store? | | | | | "John Riggs" > wrote in message | news:1124038737.457777f845c8c53d3126125312a6b7e6@b ubbanews... | > Well, your 4WD won't work anymore if you leave it off ;-) | > | > seriously, if this is an issue for you, you could always install manual | > hubs. Some of us really like them better. It gives us more control over | > when | > the 4X4 is engaged or not. Without the hubs engaging, it doesn't make a | > hill | > of beans if the X-fer case is engaged or not. The hubs aren't all | > expensive | > of an investment in your own peace of mind. | > | > | > "Carl Montgomery" > wrote in message | > news:vxKLe.2955$%K4.2473@trnddc09... | > |I have a 97 Explorer XLT... | > | | > | I had Ford replace the engine and transfer case, both junk yard parts | > and | > | now I can't get it to stay out of 4 wheel auto. It hops when I turn | > corners | > | and sometimes stops the truck. | > | | > | I removed the front drive shaft to confirm that it was the problem does | > | anyone know if there will be a problem if I leave the front drive axle | > | off?? | > | | > | Thanks, | > | Carl | > | | > | | > | > | | |
#9
|
|||
|
|||
Thanks,
I will look into that, thanks for the responses, you been a great help... "John Riggs" > wrote in message news:1124149911.e4a083551c15924d3b015abf93fe4d0c@b ubbanews... > Usually. > > > "Carl Montgomery" > wrote in message > news:AB8Me.4698$H_4.2519@trnddc07... > | Can I get the hubs from the auto parts store? > | > | > | > | > | "John Riggs" > wrote in message > | news:1124038737.457777f845c8c53d3126125312a6b7e6@b ubbanews... > | > Well, your 4WD won't work anymore if you leave it off ;-) > | > > | > seriously, if this is an issue for you, you could always install > manual > | > hubs. Some of us really like them better. It gives us more control > over > | > when > | > the 4X4 is engaged or not. Without the hubs engaging, it doesn't make > a > | > hill > | > of beans if the X-fer case is engaged or not. The hubs aren't all > | > expensive > | > of an investment in your own peace of mind. > | > > | > > | > "Carl Montgomery" > wrote in message > | > news:vxKLe.2955$%K4.2473@trnddc09... > | > |I have a 97 Explorer XLT... > | > | > | > | I had Ford replace the engine and transfer case, both junk yard > parts > | > and > | > | now I can't get it to stay out of 4 wheel auto. It hops when I turn > | > corners > | > | and sometimes stops the truck. > | > | > | > | I removed the front drive shaft to confirm that it was the problem > does > | > | anyone know if there will be a problem if I leave the front drive > axle > | > | off?? > | > | > | > | Thanks, > | > | Carl > | > | > | > | > | > > | > > | > | > > |
#10
|
|||
|
|||
You're probably just leaving out bits of the story that are irrelevant from
your point of view, but I'd think they would have wanted to fix it or at least tell you what was needed to fix it, before installing it (or would have done so, once they did a test drive after installation). Given the condition in whuch they handed it over to you, it's somewhat a safety hazard. Still scratching my head, as replacing the hubs seems like a round-about way to 'fix' the problem and not exactly cheap, either. -- "Carl Montgomery" > wrote in message news:6D8Me.4699$H_4.2063@trnddc07... > I did... they said it is not their problem and they wired it right. They > said that it was due to the fact that it was a junk yard transfercase. > Donley in Galion,OH was not much help after the repair. > > > > "Herb Kauhry" > wrote in message > ... > >I can't figure out why you haven't taken it back to Ford to have them put > >it > > back together correctly... > > > > -- > > > > "Carl Montgomery" > wrote in message > > news:vxKLe.2955$%K4.2473@trnddc09... > >> I have a 97 Explorer XLT... > >> > >> I had Ford replace the engine and transfer case, both junk yard parts and > >> now I can't get it to stay out of 4 wheel auto. It hops when I turn > > corners > >> and sometimes stops the truck. > >> > >> I removed the front drive shaft to confirm that it was the problem does > >> anyone know if there will be a problem if I leave the front drive axle > >> off?? > >> > >> Thanks, > >> Carl > >> > >> > > > > > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
William Clay Ford Jr. - Not your great-grandfather's Ford. | Grover C. McCoury III | Ford Mustang | 8 | April 24th 05 09:04 PM |
Great News For The Ford Faithful! | [email protected] | Ford Mustang | 0 | March 29th 05 05:04 AM |
FS: Working 1993 Ford Explorer Limited HAMILTON, ONTARIO | [email protected] | Ford Explorer | 0 | March 8th 05 04:11 AM |
98 Explorer EB Edition Climate Control is to cost $ 550.00 | Dirty | Ford Explorer | 1 | February 23rd 05 11:51 AM |
92 FORD EXPLORER HYDROPLANE PROBLEM AT 45 MPH OR MORE.. | [email protected] | Ford Explorer | 10 | December 26th 04 10:48 PM |