If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Lens Cover came off Parking/Turn Lamp
Seems like the easiest way to put it back on would be Epoxy. Good idea?
Better idea? |
Ads |
#2
|
|||
|
|||
Lens Cover came off Parking/Turn Lamp
|
#3
|
|||
|
|||
Lens Cover came off Parking/Turn Lamp
Epoxy should be alright. Make sure both surfaces are clean & dry. I
would also run a bead of silicone sealer around the outside of the housing & lens edge. harryface |
#4
|
|||
|
|||
Lens Cover came off Parking/Turn Lamp
Harry Face wrote: > Epoxy should be alright. Make sure both surfaces are clean & dry. I > would also run a bead of silicone sealer around the outside of the > housing & lens edge. > > > harryface I always just used silcone only. Always knew that if I needed to remove it, with silcone, I could. I think half the lights on my '79 Datsun were held on -- well -- by silcone. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How Do I Replace 96 Mustang Headlight Lens Cover Assembly | [email protected] | Ford Mustang | 3 | March 18th 06 02:58 AM |
AWA [OFFER] 99-00 Caravan Front cover w/fog lamp holes | [email protected] | General | 0 | December 29th 05 07:51 PM |
Headlight lens cover... | Troy Bruder | Audi | 4 | April 1st 05 04:47 PM |
Fog Lamp lens | Thomas Misek | Mazda | 9 | March 26th 05 05:34 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | March 21st 05 05:33 AM |