If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Trick for swollen inner brake hoses
those flexible rubber hoses that run to the wheel, swell up inside and
tho the brakes may go on, they don't release. How to tell, the brakes get hot! my trick is to saw them off at the rubber /metal end. and use a deep socket wrench to loosen them. works like a charm. esp. at the junction block in the rear. -- Karma, What a concept! |
Ads |
#2
|
|||
|
|||
Trick for swollen inner brake hoses
On 8/17/2012 6:55 PM, Viet Vet wrote:
> those flexible rubber hoses that run to the wheel, swell up inside and > tho the brakes may go on, they don't release. > How to tell, the brakes get hot! > my trick is to saw them off at the rubber /metal end. and use a deep > socket wrench to loosen them. works like a charm. esp. at the junction > block in the rear. 100% true. I would not even try an open wrench on them if the hose (or hard line) is getting replaced, you just risk rounding off the nut. Cut it first, then you can get a snug fitting 6-point deep socket on it. |
#3
|
|||
|
|||
Trick for swollen inner brake hoses
Gotta do that when I get a bit of time ( ie when I,m not looking after
Grandkids!). Was wondering about job with lousy access. Good idea. "Jan Andersson" > wrote in message ... > On 8/17/2012 6:55 PM, Viet Vet wrote: >> those flexible rubber hoses that run to the wheel, swell up inside and >> tho the brakes may go on, they don't release. >> How to tell, the brakes get hot! >> my trick is to saw them off at the rubber /metal end. and use a deep >> socket wrench to loosen them. works like a charm. esp. at the junction >> block in the rear. > > > 100% true. I would not even try an open wrench on them if the hose (or > hard line) is getting replaced, you just risk rounding off the nut. Cut it > first, then you can get a snug fitting 6-point deep socket on it. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Integra brake switch replacement -- is there some sort of trick to this? | Remco[_1_] | Honda | 1 | June 11th 07 03:37 AM |
Trick To Fan?.... | Peter Griffin | Technology | 3 | April 14th 06 11:37 PM |
BMX trick to check mileage using key and brake | flesjespa | Technology | 0 | January 13th 06 11:55 AM |
Anybody know the speed display trick? | Daz N | Audi | 7 | May 24th 05 06:27 PM |