|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 17th 06, 01:11 PM
posted to alt.autos.corvette
|
|||
|
|||
'96 acrylic top splitting
I have a 96 vette with a acrylic top that has split in the middle twice in
the last year. I have been told that it is a body flexing problem, cheap replacement top, incorrect installation....ect. any thoughts on this would be appreciated as I am tired of replacing them. Thanks Kevin 
|
| Ads |
|
#2
September 19th 06, 12:34 AM
posted to alt.autos.corvette
|
|||
|
|||
|
'96 acrylic top splitting
Body flex is the problem..GM engineering screw up as usual....buy the body X
braces for a convertible and install them it ....will cure the problem... Braces are still available from GM cost is about $350 for all three pieces..bolts right up to you frame..excellent at stabilizing the body flex/twist. ALL VETTES SHOULD HAVE HAD THEM NOT JUST CONVERTIBLES>>>!!!!!!!!!!!!!!!
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine Rebuild and Case Splitting | [email protected] | VW air cooled | 5 | June 30th 06 09:37 PM |
| Auto Paint on Acrylic? | Mike Nelson | Corvette | 1 | November 20th 05 05:04 PM |
| 2k over acrylic | 57oval | Technology | 0 | June 9th 05 08:17 AM |
| painting car, acrylic lacquer | james | Technology | 1 | January 19th 05 10:57 PM |
| Does anyone know where you can buy acrylic alcquer paint in Florida? | Tom in Missouri | Corvette | 3 | August 19th 04 05:45 AM |
Linear Mode
