If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1992 OLDS CEIRA,starts cool,gets warm,cuts off,won't start
please help,replaced all 3 coils,starts cool,runs,gets warm,cuts off,let it
cool,starts right up.All answers appreciated.Will check for spark today to sparkplugs after it cuts off. |
Ads |
#2
|
|||
|
|||
fixer wrote:
> > please help,replaced all 3 coils,starts cool,runs,gets warm,cuts off,let it > cool,starts right up.All answers appreciated.Will check for spark today to > sparkplugs after it cuts off. Sounds like the crank sensor going bad... or ign module. |
#3
|
|||
|
|||
bad relay or senser
|
#4
|
|||
|
|||
today,by the way this is a 3.3 engine,it's losing fire to spark-plugs,when
it cuts off,no warning codes,i'm leaning toward the camshaft sensor.Does anyone have any tips in changing this sensor,besides a lot of praying?What tool do u use to make sure u have it the correct distance from the crankshaft pulley?Thanks for all your helpful replies. |
#5
|
|||
|
|||
fixer wrote:
> > today,by the way this is a 3.3 engine,it's losing fire to spark-plugs,when > it cuts off,no warning codes,i'm leaning toward the camshaft sensor.Does > anyone have any tips in changing this sensor,besides a lot of praying?What > tool do u use to make sure u have it the correct distance from the > crankshaft pulley?Thanks for all your helpful replies. You probably meant crankshaft sensor? The hardest part is removing the dampner. You can try wedging in a breaker bar on the nut and tapping the starter or use a quality impact running 100+ psi. I use the impact method. Here is a link to a similar sensor install: http://www.vortexbuicks-etc.com/cranksensor.htm |
#6
|
|||
|
|||
thx.Paul,you're correct,crankshaft sensor,u been so helpful,thank you so
much. |
#7
|
|||
|
|||
thx. 4 your help.
|
Thread Tools | |
Display Modes | |
|
|