If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
replacing stud?
my friend just bought a 2001 gt. well this weekend we where putting new
brakes and rotors on the front, and discovered a broke off lug stud bolt. has anyone replaced one of these or know how its done? looks like the treads were crossed and it snapped off. not enough stud to hold on a lug nut. thanks for any help. mp |
Ads |
#2
|
|||
|
|||
replacing stud?
Michael price wrote:
> my friend just bought a 2001 gt. well this weekend we where putting new > brakes and rotors on the front, and discovered a broke off lug stud > bolt. has anyone replaced one of these or know how its done? looks like > the treads were crossed and it snapped off. not enough stud to hold on a > lug nut. thanks for any help. mp > Front or rear? Essentially, you need to remove the part that the stud goes through. Take it to a machine shop and have them press out the old one and press in a new one. I'v tried doing it with a large C clamp, but that didn't work for me. Don't use a hammer. -- ..boB 2006 FXDI hot rod 2001 Dodge Dakota QC 5.9/4x4/3.92 1966 Mustang Coupe - Daily Driver 1965 FFR Cobra - 427W EFI, Damn Fast. |
#3
|
|||
|
|||
replacing stud?
".boB" > wrote in message om... > Michael price wrote: >> my friend just bought a 2001 gt. well this weekend we where putting new >> brakes and rotors on the front, and discovered a broke off lug stud >> bolt. has anyone replaced one of these or know how its done? looks like >> the treads were crossed and it snapped off. not enough stud to hold on a >> lug nut. thanks for any help. mp >> > Front or rear? > > Essentially, you need to remove the part that the stud goes through. Take > it to a machine shop and have them press out the old one and press in a > new one. > > I'v tried doing it with a large C clamp, but that didn't work for me. > Don't use a hammer. > most tire places can do it |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wheel stud washers for LH? | Greg Houston | Chrysler | 2 | July 1st 06 10:03 PM |
99 XLT replacing wheel stud advice | Mikepier | Ford Explorer | 1 | February 4th 06 03:03 PM |
AWA [OFFER] CD stud welder,CD weld stud | [email protected] | General | 0 | January 29th 06 02:54 PM |
AWA [OFFER] CD stud welder,CD weld stud | [email protected] | General | 0 | January 29th 06 02:53 PM |
Lost a head stud!! | Mike Fritz | VW air cooled | 4 | November 7th 05 07:44 PM |