If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
>Megasquirt + Audi 80 2.6 liters V6
Does anyone have a "how to" on a Audi 80 2.6 liters v6 1993 mod ?
the engine code is ABC. The engine is stock. The items i have is: Megasquirt II , 3.0 Main Board, set up for Hall sensor and dual MAP sensors installed. MSD 6AL ignition standard injectors 4 MSD 72 lb/hr injectors, rated for alcohol. Innovate LC-1 Digital Wideband Controller with Sensor. DIY autotune relay card with cable to MS box. I want to obtain the correct ECU connector, i think it is a bosh 80 pin, so i can use the standard sensors and the standard connector. this is because if something goes wrong with the MS2 box, it is possible to just plug it out and replace it with the standard one. Does anyone have the pinout for the connector ? I want to run fuel and ignition. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Megasquirt ECU | Don[_17_] | Mazda | 1 | November 24th 08 10:02 PM |
MegaSquirt FFV use? | Bret Ludwig | Technology | 5 | November 6th 05 03:47 PM |
HELP-*imitaion* high stall torque converter for the 2.8 - 3.1 liters ? | test | Technology | 1 | May 30th 05 11:50 PM |
Megasquirt? | Tim Wohlford | VW water cooled | 1 | January 10th 05 10:58 PM |
Test Mustang 2005 GT 4.6 liters by Richard Hammond (29 MB) | Frans Nijhuis | Ford Mustang | 0 | December 24th 04 04:28 PM |