If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
what if mesh guard for MAF sensor is missing?
I noticed in two different cars that the airflow sensor was missing
the honeycomb mesh guard that is used to promote laminar flow across the wires. What is the effect of this? I presume the mixture would be too rich or lean, but then the ECU would monitor the exhaust oxygen sensor and would correct this after a while. BTW both cars seemed to run OK. |
Ads |
#2
|
|||
|
|||
what if mesh guard for MAF sensor is missing?
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
j & s safe guard / knock sensor | peter | Mazda | 0 | June 17th 09 03:45 AM |
03 JGC - "Tire Pressure Sensor Bad/Missing"??? | USA | Jeep | 13 | April 10th 07 06:05 AM |
03 JGC: Tire Pressure Sensor "BAD/MISSING"???? | USA | Jeep | 0 | April 6th 07 04:05 AM |
brake sensor missing front wheel psgr side | avinator | BMW | 11 | June 9th 06 05:35 PM |
Question: Can synchro-mesh be adjusted? | BD | Technology | 19 | October 4th 05 07:11 PM |