If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
5.2L Shake Shake Shake
I have a 1984 5th Ave with the 5.2L(318) engine. It will start ok when
cold, but after I drive it for a bit, Let it sit for, oh, about a half hour, then start it again, the engine shakes so much that it feels like my teeth are going to come loose. Once it's going, it drives ok, that is until I come to a stop. Then it starts shaking all over again. I mean BAD. Almost (and sometimes does) stall. Does anyone have an idea as to what may be causing this? Thanks. Tubbsy |
Ads |
#2
|
|||
|
|||
"" wrote:
> I have a 1984 5th Ave with the 5.2L(318) engine. It will start > ok when > cold, but after I drive it for a bit, Let it sit for, oh, > about a half > hour, then start it again, the engine shakes so much that it > feels like > my teeth are going to come loose. Once it's going, it drives > ok, that > is until I come to a stop. Then it starts shaking all over > again. I > mean BAD. Almost (and sometimes does) stall. Does anyone have > an idea > as to what may be causing this? Thanks. > > Tubbsy sounds like it might be idleing to low when the engine gets warmed up. a tuneup should fix this easy enough. and if its carb driven even easier.. there should be a screw on the side of the carb, just turn it. -- Posted using the http://www.autoforumz.com interface, at author's request Articles individually checked for conformance to usenet standards Topic URL: http://www.autoforumz.com/2L-Shake-S...ict141996.html Visit Topic URL to contact author (reg. req'd). Report abuse: http://www.autoforumz.com/eform.php?p=687202 |
#3
|
|||
|
|||
The only thing that stumps me is that it idles fine even after it is
warmed up. I can drive 20 miles and the engine is fine, even in stop & go traffic. It's only after it sits for a short period of time (after it starts to cool down, but before it's cold) that I have the problem. Personally, I think it's a carb problem, but I don't know what to adjust. It's not anywhere as simple as my 1967 Dodge Coronet (which had a 318) was to work on WAY back in 1982. TOO much smog crap on this car. And Lean Burn? I don't even know where to start. Thanks. Tubbsy |
#4
|
|||
|
|||
The pickup coil/ring in the distributor? Vacuum leak?
Bob AZ |
#5
|
|||
|
|||
> > I have a 1984 5th Ave with the 5.2L(318) engine. It will start > > ok when > > cold, but after I drive it for a bit, Let it sit for, oh, > > about a half > > hour, then start it again, the engine shakes so much that it > > feels like > > my teeth are going to come loose. Once it's going, it drives > > ok, that > > is until I come to a stop. Then it starts shaking all over > > again. I > > mean BAD. Almost (and sometimes does) stall. Does anyone have > > an idea > > as to what may be causing this? Thanks. > > > > Tubbsy > Another thing that sometimes happens on carburetors (remember those?? this car's got one!) is that one idle circuit will cease working entirely due to being dirty, damaged, or improperly adjusted. When that happens, the car only idles on 4 cylinders (if a v8 and using a dual-plane intake like a stock 318/5.2 does). Feels a little like sitting inside a paint shaker. Try backing the idle adjustment screws on the front of the carb ALL the way out (removing them) and blasting carburetor cleaner into the holes where they went. Clean the screws with carburetor cleaner and a soft cloth (don't lose the little springs that go with the screws!) and then reinstall them and adjust the idle mixture. If you don't have a service manual that gives the procedure for setting the idle, bottom the screws out (GENTLY!) and then back off 2 turns start the car and warm it up, then adjust for the smoothest/fastest idle or (better yet) highest manifold vacuum reading. You'll have to adjust both screws, then adjust the idle speed back to spec, then re-adjust both screws again for several iterations. |
#6
|
|||
|
|||
Well, I played around with the vacuum lines yesterday, and come to find
out, there was one plugged into the wrong place (I assume) in the passenger's side firewall. I have NO idea what the thing does, but the connections look like identical twins with inlets (outlets?) on the top, bottom and side of whatever the heck the connections are for (do I sound like a heart Dr?). As soon as I unplugged one hose from the firewall connection, the car started idling perfect. I'm stumped as to what the connections are suposed to do. All I know now is that I have a vacuum line connected to nothing, a twin "unit" on the firewall pretty much connected to nothing (now), but the car idles much, MUCH better. If I haven't said it before, I HATE emission controls!!!!!!!! Tubbsy |
#7
|
|||
|
|||
5.2L Shake Shake Shake
tubbco15 wrote:
> Well, I played around with the vacuum lines yesterday, and come to find > out, there was one plugged into the wrong place (I assume) in the > passenger's side firewall. I have NO idea what the thing does, but the > connections look like identical twins with inlets (outlets?) on the > top, bottom and side of whatever the heck the connections are for (do I > sound like a heart Dr?). As soon as I unplugged one hose from the > firewall connection, the car started idling perfect. I'm stumped as to > what the connections are suposed to do. All I know now is that I have a > vacuum line connected to nothing, a twin "unit" on the firewall pretty > much connected to nothing (now), but the car idles much, MUCH better. > If I haven't said it before, I HATE emission controls!!!!!!!! > > Tubbsy > Most likely the EGR control valve (your description wasn't that bad :-) The EGR servo is located on the maifold by the carb- watch/feel for its stem to move when you plug that line in. If it does, then you've found the issue. That control valve should enable EGR when the engine is warm, but it shouldn't engage it at idle. Don't know if you'll pass an emissions test with the EGR deactivated the way it is now, but if you don't have to have a test in your area, you're OK. Be observant to see if it pings any worse than it did before- EGR actually helps suppress detonation, but the feedback carb engine control systems on the M-body didn't really depend on EGR the way some EFI cars of that era (notably the Cadillac 4100) did to prevent self-destruction. |
#8
|
|||
|
|||
5.2L Shake Shake Shake
motor mount?
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shake & Shine World's Fastest Cleaner & Polish | W | Ford Mustang | 1 | September 15th 05 01:03 AM |
Shake & Shine World's Fastest Cleaner & Polish | W | BMW | 0 | September 15th 05 01:01 AM |
Shake & Shine World's Fastest Cleaner & Polish | W | Honda | 0 | September 14th 05 08:54 PM |
Shake & Shine World's Fastest Cleaner & Polish | W | BMW | 0 | September 14th 05 08:54 PM |
steering shake | italian_72 | VW water cooled | 2 | May 27th 05 03:28 PM |