If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
gtv cambelt
"Catman" > wrote in message ... > Zathras wrote: >> On Mon, 15 Mar 2010 14:30:12 +0000, Catman >> > wrote: >> >>> Never get a 12v V6 then. They can jump teeth if you let it roll >>> backwards in gear...... >> >> Ahhh..I was trying to remember which one did that! >> > > Not the greatest tensioner design to ever hit the road One of the 'boxer' engined Lancias had an even worse issue - on full left steering lock, I recall, you can cause the cambelt to jump. -- SteveH |
Ads |
#12
|
|||
|
|||
gtv cambelt
Steve H on the road wrote:
> > "Catman" > wrote in message > ... >> Zathras wrote: >>> On Mon, 15 Mar 2010 14:30:12 +0000, Catman >>> > wrote: >>> >>>> Never get a 12v V6 then. They can jump teeth if you let it roll >>>> backwards in gear...... >>> >>> Ahhh..I was trying to remember which one did that! >>> >> >> Not the greatest tensioner design to ever hit the road > > One of the 'boxer' engined Lancias had an even worse issue - on full > left steering lock, I recall, you can cause the cambelt to jump. > *wow* -- Catman MIB#14 SKoGA#6 TEAR#4 BOTAFOF#38 Apostle#21 COSOC#3 Tyger, Tyger Burning Bright (Remove rust to reply) 116 Giulietta 3.0l Sprint 1.7 GTV TS GT 3.2 V6 Triumph Sprint ST 1050: It's blue, see. www.cuore-sportivo.co.uk |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1.9 JTD 156 Cambelt(s) | Jim[_32_] | Alfa Romeo | 3 | March 3rd 10 11:39 AM |
JTD cambelt | cupra | Alfa Romeo | 36 | March 28th 07 08:31 AM |
Cambelt at 18K | Pete | Alfa Romeo | 12 | May 15th 06 09:31 PM |
Cambelt on a 156 | GT | Alfa Romeo | 2 | October 18th 05 09:29 PM |
156 2.0TS Cambelt @ 65k | colhum1 | Alfa Romeo | 13 | June 10th 04 08:37 PM |