If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Wire cut need to change the whole wheel on a C5
Hi to all,
The wire that goes in the whell has been cut. This wire enables the ABS, stability control and antiskid to run. The garage owner told me that I have to change the whole wheel : hub with everything around it.....it will cost me about 800 euros for that. Do anyone would recommand me a another solution. Thanks for any help. Jacques Moreau. |
Ads |
#2
|
|||
|
|||
How did the wire get cut? Where is the cut? On the hub side or on
the wiring harness side? Why can't the wire be spliced? Or just replace the harness? Check out www.c5forum.com or www.corvettemechanic.com for more help. On Tue, 10 Aug 2004 07:49:38 +0200, "Fred" > wrote: >Hi to all, > >The wire that goes in the whell has been cut. This wire enables the ABS, >stability control and antiskid to run. >The garage owner told me that I have to change the whole wheel : hub with >everything around it.....it will cost me >about 800 euros for that. >Do anyone would recommand me a another solution. > >Thanks for any help. > >Jacques Moreau. > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Alcantara sttering wheel cover on 330i - replacement? | GRL | BMW | 2 | May 22nd 06 12:40 AM |
BMW-525I - oil change frequency | AGIND | BMW | 29 | December 19th 04 03:11 PM |
Radio Controls on Steering Wheel 147 | Paul Woodsford | Alfa Romeo | 0 | October 31st 04 05:56 PM |
missing wheel nut adaptors | John Brunt | Alfa Romeo | 7 | October 20th 04 10:21 PM |
A4 - Front Wheel Bearings ? | Graeme | Audi | 1 | July 15th 04 12:47 PM |