If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
O2 Sensor wire
Exactly where does the O2 sensor wire go to? I know there's a plug
underneath by the axle to change it. I'd like to know where it 'terminates'. I see to have a bad connection and need to trace the entire wire. tia, -- Mel P. 96 Jeep Cherokee |
Ads |
#2
|
|||
|
|||
the 02 sensor screws into your exhaust
"Mel P." > wrote in message ... > Exactly where does the O2 sensor wire go to? I know there's a plug > underneath by the axle to change it. I'd like to know where it > 'terminates'. I see to have a bad connection and need to trace the entire > wire. > > tia, > > -- > Mel P. > 96 Jeep Cherokee > > |
#3
|
|||
|
|||
I think it plugs in near your oil filter, it should be easy to follow up
from the header pipe. What year are you talking about? KH "IsellJeeps" > wrote in message om... > the 02 sensor screws into your exhaust > > > "Mel P." > wrote in message > ... >> Exactly where does the O2 sensor wire go to? I know there's a plug >> underneath by the axle to change it. I'd like to know where it >> 'terminates'. I see to have a bad connection and need to trace the >> entire >> wire. >> >> tia, >> >> -- >> Mel P. >> 96 Jeep Cherokee >> >> > > |
#4
|
|||
|
|||
He asked where the 02 wiring terminates, not where the 02 sensor mounts.
IsellJeeps wrote: > the 02 sensor screws into your exhaust > > > "Mel P." > wrote in message > ... > >>Exactly where does the O2 sensor wire go to? I know there's a plug >>underneath by the axle to change it. I'd like to know where it >>'terminates'. I see to have a bad connection and need to trace the entire >>wire. >> >>tia, >> >>-- >>Mel P. >>96 Jeep Cherokee >> >> > > > -- Jerry Bransford PP-ASEL N6TAY See the Geezer Jeep at http://members.cox.net/jerrypb/ |
#5
|
|||
|
|||
Mel P. did pass the time by typing:
> Exactly where does the O2 sensor wire go to? I know there's a plug > underneath by the axle to change it. I'd like to know where it > 'terminates'. I see to have a bad connection and need to trace the entire > wire. Should be similar to my 93, but YMMV. Best bet is to go visit the dealer and ask to read the service manual. From the sensor Color (stripe) Black (tan) - Ground to a splice in the harness Orange (dark blue) - 12V to the fuel pump relay (pin 9) Black (light blue) - Reference ground (pin 4 of ECU) along with many other sensors. Black (orange) - O2 sensor wire to pin 41 of the ECU -- DougW |
Thread Tools | |
Display Modes | |
|
|